Recent content by JP11
-
J
'16 Have to Slam Top Console Lid
have that with my 14. of course the dealership "cannot recreate" what im saying is happening.. -
J
2014 ram 1500 - LEDs with stock projectors
Hey guys, looking to get some LEDs for my low beams. I have the stock projectors. I read the OPT7 don't fit because of the dust cap, is this true? If so, what are my alternatives? bulb size? Thanks :) -
J
Pool of oil inside KN Intake pipe.
Hey guys, went to go clean my KN Short ram filter today, took it off and noticed it started leaking out and there was a little pool of it inside the pipe. I did change my oil last week so could it be from that? Ive cleaned the intake before and never had this before. Any idea what could...- JP11
- Thread
- Replies: 8
- Forum: Engine & Performance
-
J
Zone 1.5" body lift
Ive got half mine installed, doing the cab tomorrow. Relocating the bumper was the hardest part. -
J
Rattling/Clunking since i put 35s on.
It happens whenever i hit a bump (i.e., a manhole, curb etc).- JP11
- Post #12
- Forum: General Discussions
-
J
Rattling/Clunking since i put 35s on.
think that would cause a metal sounding noise though?- JP11
- Post #9
- Forum: General Discussions
-
J
Rattling/Clunking since i put 35s on.
Nah it was done at the shop. Ive tightened everything up. Stock 20s- JP11
- Post #4
- Forum: General Discussions
-
J
Rattling/Clunking since i put 35s on.
Hey guys, I put 35's on my truck a couple months back and as soon as i put them on theres think rattling/clunking coming from the front passenger side of the truck. I have a zone levelling kit and .25" Wheel spacers. The dealership diagnosed it as a problem with the sway bar so they replaced it...- JP11
- Thread
- Replies: 11
- Forum: General Discussions
-
J
Block lifts?
Maybe start with a levelling kit? (Bilstein 5100's maybe?). Then theres either a RCX 1.25", Performance accessory 3", or Zone 1.5" Bodylifts available. All are under $400 (Installation on top of that though). bilsteins and a 1.5" BL would put you around 4" of lift up front for $450ish -
J
Anything I should know..?
Very delayed here lol. Looks awesome salt break. Hows it been thus far? Going to pull the trigger in the next week unless you or someone else can convince me otherwise lol...
