The only modification i did to the bumper was cut a hole in the plastic. the bumper sits the same as it did before the mount was installed. The mount is bolted with (6) 1/2'' bolts to the frame.
I started with a draw-tite service truck 16,000lb rear hitch (part no.41990-07). Cut the tube to 30.5 inches and welded the end plates on. To get it out in front of the bumper i welded a 14'' extension tube in front and (2) 45 degree supports.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.