So. Had the wife move the truck while I listened. Sounded.like.the noise was more in the middle of the truck. So I removed front driveline and noise was still there. Can I remove the cv axles and see if the noise is gone? That should tell me if the noise is the axles or front diff cause it wont...
Yea. Gonna have the wife move it. Seems like the noise is on driver side. But might be diff. Is there a way to check the fluid? Also, with it jacked up, I spin the tire and can hear a slight tick tick. Could the hub bearing be bad?
So I replaced lower ball joints and the noise is still there. It makes a loud banging noise if I have the wheel turned to the right slightly and back up slowly. Then pull forward again still leaving wheel in same spot and bang bang. Does it again. Any ideas? Going nuts!!
Thanks guys. Thinking more and more its the lower ball joints. It made the noise today backing up while holding the steering wheel in one position slightly turned. Didn't move the wheel at all. Think I can hear it mostly on driver side and every once in a while pas side. So both prob bad. Sound...
Mostly happens with the wheel turned right and while backing up then going forward again. Checked the brakes and slides are free and moving. Noticed if I have it in drive and apply the brake and turn the wheel, I can hear the lower ball joints creeking but no popping. I also found a...
The sound is coming from driver side. And I already replaced the cv axle. Sound is driving me nuts!! Guess I'll look into replacing the rack. Anyone know of a write up on a rack replacement?
Ok. So I am now in the process of replacing inner tie rod due to some play. Upon inspection I noticed the play is in the shaft that the inner tie rod connects to. Also there is pink grease everywhere inside the inner rod boot. Should there be play on that steering shaft? (Can wiggle it side to...
Thanks everyone. I still haven't replaced lower ball joints but can't see any play in them if I move the tire at 12 & 6. How can I check the caliper slide? And finally, yes have bounced the truck up and down and side to side. I can't replicate the noise at all unless I start backing out of my...
So I found that the sway bar bushings are cracked and broken. The parts store had two sets. One for a 32mm bar and one for 33 or 34 I think. Does anyone know what size mine is? 04 1500 4x4 qc. Thanks
Hello everyone I have a 04 1500 4x4. At very low speeds there is a clunking sound on front drivers side. It only happens when backing up with the wheel turned and then going forward again. Like backing out of my driveway. Its usually three clunks while backing up then three when I start moving...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.