The front bumper I left on, but the back bumper i took off and put it on two saw horses. They are both heavy enough that they shouldn't move too much when stretching if you prop them up good enough.
Make sure you use two people though, way easier for stretching/heating purposes
Hey I used Avery Vinyl wrap, gloss white. I did it myself and I want to say that the material for both costed me around $100 Canadian. I got it from ND Graphics here in Canada. It came in dimensions of 5 feet by however much you want length wise...
It takes a lot of patience to do though, lots...
I can't exactly remember the exact measurements, I used a tape measure and then got the closet amount that would work with a little bit extra from the local guys here
Nice! Good luck with the install! I love these lights, they make so much of a difference.
I also have another pair of perfect condition LED tails I am selling if anyone is interested! These will also need the harness from wayned87
I am selling a pair of Ram LED Tail Lights and Third Brake Light SOLD
Will work with:
- 13+ Models W/ Factory LED's
- 13+ Models W/out Factory LED's (with added conversion harness)
- 09 to 12 Models (with added conversion harness)
These do NOT have the wiring on the back of them
If...
I was in the same situation as you. Luckily I found a pair with wires attached and sold the previous ones that were without.
While searching however, I came across a guy on the Cummins forum that makes and sells these wiring harnesses. I think he sells the for $50 shipped to US, $75 shipped to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.