Recent content by Michael Heck
-
M
2008 ram 1500 4.7 swap from 2010 durango 4.7
Well it ended up being a ground after putting another groung on. the one that went to the firewall and to each of the heads . That was not enough. Added a ground cable to the battery to the head and started right up.Crazy when you think you have a good enough ground it end up not being enough.- Michael Heck
- Post #7
- Forum: General Discussions
-
M
2008 ram 1500 4.7 swap from 2010 durango 4.7
I used the harness off the old engine. Someone spliced those wires in. And i do not remember taking those off. I never have this problem before and have done hundreds of motors over the years.- Michael Heck
- Post #6
- Forum: General Discussions
-
M
2008 ram 1500 4.7 swap from 2010 durango 4.7
This is what i have found under the fuse box.Still not getting nothing fuel pump not turning on just a ckick unless i jump it through the fuse panel not sure if it is th=e right way to jump it but it works for me.Any ideas where these belong they are on drivers side they are hooked uonwith the...- Michael Heck
- Post #4
- Forum: General Discussions
-
M
2008 ram 1500 4.7 swap from 2010 durango 4.7
Well the ground is good I even took jumper cables from the battery and grounded it to the engine and still the same. I can jump over the starter and make the engine turn over but no fire and or fuel. would there be a security issue? I aslo changed the selonoid on the fender and still no luch. I...- Michael Heck
- Post #3
- Forum: General Discussions
-
M
2008 ram 1500 4.7 swap from 2010 durango 4.7
I have been having a problem. i bought a 4.7 from a donar 2010 durango. Installed it in a 2008 ram 1500 that had a 4.7 in it already. It did have 16 plugs. seemed all to be the same but the knock sensor cable end. I can not get it to turn over just clicks. Motor did run in the durango. Could use...- Michael Heck
- Thread
- Replies: 6
- Forum: General Discussions
-
M
wiring issues
well that was not it. fixed the wireing and will not shift out of 2nd gear. I have changed shift solionoid. Or by chance do you think the wire being grounded out messed the new one up also? I looked further and the ground strap on the right side by the bellhousing was in 2 pieces . did not look...- Michael Heck
- Post #2
- Forum: General Discussions
-
M
wiring issues
I bought a 2007 from my friend because the transmission went into limp mode and he was tired of fixing it. well i thought it was the shifting solenoid so i replaced it and still in limp mode read the codes with superchip and can not remember what codes they were at this point. so along with...- Michael Heck
- Thread
- Replies: 2
- Forum: General Discussions
