Recent content by PaulPool89

  1. P

    No overdrive, can't shift to 1st and 2nd

    Thank you both for the quick reply! He was already planning to take it to the shop soon, so I advised him sooner than later and not to drive it. I will post an update when we find out what it is.
  2. P

    No overdrive, can't shift to 1st and 2nd

    Hello everyone! Hope you can help me out. My father in law has a 2010 Dodge Ram Laramine. Full cab. 71k miles. Tans fluid has not been changed yet. His automatic transmission has been acting up. It started right after he cleared the light for engine oil change. It's like the over drive will...
  3. P

    replaced almost everything, still no brakes

    yes I bench bled them properly. Just changed the master cylinder again on the off chance I got a deffective one. Still the same issues. And no I did not have my motor running while I bled everything.
  4. P

    replaced almost everything, still no brakes

    When I pump the brakes fluid is bubbling back up the master cylinder. What does that mean?
  5. P

    replaced almost everything, still no brakes

    Yes they are engaging. took off rear drums again and found the cylinders to suck air. Replaced them. Replaced proportioning valve. I changed the master cylinder I got yesterday for a new one just to be sure. Same problem persists. I am baffled. I can pump them up and as long as I keep...
  6. P

    replaced almost everything, still no brakes

    Yes I've been standing on the pedal and my buddy checked and rechecked. This whole day haven't noticed any leaks and we visually looked over all the lines.
  7. P

    replaced almost everything, still no brakes

    I did the booster test according to hynes manual and it seems air tight. Still have the same problem. I can pump the brakes up and they will be firm but after taking my foot off a few moments it will sink all the way down to the ground when I try them again.
  8. P

    replaced almost everything, still no brakes

    Even if the brake booster wasn't working the pedal shouldn't be going all the way to the floor right? It seems fine though.
  9. P

    replaced almost everything, still no brakes

    Yes on all three. The problem hasn't went away and I've been at it since yesterday.
  10. P

    replaced almost everything, still no brakes

    Not in any order, but then I looked in haynes and it said master cylinder first, then left rear, then right rear, then right front, then left front.
  11. P

    replaced almost everything, still no brakes

    I need some help, I'm about to give up. 2001 dodge ram 1500 5.2 magnum V8. I replaced both front brake pads, calipers, and flex lines. New master brake cylinder. I had to adjust the rear brakes because they weren't working right. I then bypassed the abs. I flushed all four wheels and master...
See more

Latest posts

Staff online

Members online

... and 1 more.
Total: 1,337 (members: 51, guests: 1,286)
Robots: 1,886

Forum statistics

Threads
195,654
Posts
2,872,990
Members
156,506
Latest member
Ibraskie

Share this page

Top