Recent content by talon6

  1. T

    408 in a 99 ram 4x4

    so it was your exhaust?
  2. T

    408 in a 99 ram 4x4

    I use hemifever. but there is nothing wrong with b&g performance. they have been tuning for a long time. I say its in your tune.
  3. T

    5.9 sucking air

    any codes?
  4. T

    46re valve body question.

    around 450$
  5. T

    Best programmer/chip for 1999 Ram 1500 with a 5.9?

    I always liked my superchip, but have to use sct(hemifever) now. satisfied with both.
  6. T

    46re valve body question.

    not for sure on the popping out of gear, but get ahold of the fastman and he can get you a valvebody made by martin sain. http://www.thefastman.com/throttle_bodies.php there is also another company that makes them, just cannt think of it right now. been wanting to try one myself. get one and...
  7. T

    Getting rid of Catalytic?

    yep , installed myself. got rid of the cat and used a fastman o2 sim. it was a tight fit for sure. but I had no issues. 3 inch single exhaust .electric cutout after the y,into a magnaflow muffler, dumped before the axel. this is last summer vid.
  8. T

    Getting rid of Catalytic?

    94-01 Dodge RAM 1500 PaceSetter Long Tube Headers used the ypipe shown too.
  9. T

    Getting rid of Catalytic?

    pacesetter lts ceramic coated is what I use. tough to get them installed but they work fine.
  10. T

    5.9L mods

    bottom end will hold up. 8lbs of boost with a 50 shot no problems here. tried a 100 shot with 8lbs and blew my headgasket.lol. very strong bottom end.
  11. T

    Pros, Cons, Magnum 5.9 Engine

    look at my sig. lots of mods there. weak plenum gasket. weak heads-some tend to crack. terrible on gas. very strong bottom end.
  12. T

    turbo

    there is a lot more to it than just dropping the turbo in and go. especially if you want it to run right and not damage your stuff.
  13. T

    turbo

    I agree. I donnt know about 20k though. you are looking at about 6-8k to do it right.not to many make a kit for our motors. but here is a good one. http://www.performanceinjectionequipment.com/Turbos.html
  14. T

    Wideband AFR Gauge Install

    I am going soon. i just need to work a few small things out first.
  15. T

    Engine makes noise during acceleration immediately after programming with Supechips

    sounds strange. you sure it isn't the valves chattering?
See more

Latest posts

Staff online

Members online

Total: 1,114 (members: 45, guests: 1,069)
Robots: 1,727

Forum statistics

Threads
195,678
Posts
2,873,233
Members
156,537
Latest member
Outdoorsman1127

Share this page

Top