Search results

  1. K

    Power steering cooler location

    Good morning, I am looking to see if anyone can answer the question of where the power steering cooler is located on the 1996 ram 2500. Is it in to rad? is it in the same spot as it is on the 1500? I'm going to be heading out to buy new steering components soon. And if it's in the rad, I will...
  2. K

    Fuel injector retaining wire and transmission question

    Hello, I had taken my truck into the dealership to have them find an issue that I couldn't figure out. While they were working on it, they had noticed the wire clip was missing on all the injectors. Would someone happen to have a photo/part number or knowledge of where to get replacements? Or...
  3. K

    Aaaand again....

    Ok, so here's the scoop. I have a 1996 2500 with the 360 v8. With replacing the TPS, Oil sender, Crank sensor, plugs, wires. And now it won't stay running unless I am holding down the gas pedal to keep the rpms up. Could there be an issue with the computer? I can hear the fuel pump, and when...
  4. K

    Running issues

    Good afternoon, Late last year I had posted about not being able to keep the engine in my truck running unless I had the gas pedal to the floor. I can't get logged in on my computer to update the post. Over the last weekend I had the chance to try a few of the suggestions in that post. But no...
  5. K

    Engine confusion

    Good afternoon folks, After using the search, mr google and the service book. I still can't figure out what's going on with the truck. I have a 1996 dodge ram 2500 with the 360 gas engine. After having the compression test done, and it reading 80 on all but 2 cylinders. I had changed the...
  6. K

    Measurements please!!

    Would anyone happen to know off hand what length of Nerf bars a guy would need? I have been looking around for a set, but all I can see are one with double foot pads on them. My Dodge is a 96 2 door. And right now I don't have access to the truck to measure what I'd need. Thanks Sent from my...
  7. K

    Manual seats

    Good afternoon community!! I have a few questions as far as the manual seats are concerned. I have a 1996 ram 2500, and it doesn't have the spare door. My seats manually slide forward amd the back of the seat folds forward. The questions I have are, is it possible to repair the latch for the...
  8. K

    Quick question on engine mod

    Good evening, Well after doing a crap ton of reading on mr google and here, my questions still hadn't been answered. I have recently become the new owner of a set of magnum heads from a 2001 5.9. And for the best possible price yet too.... The questions are will they fit on a 1996 magnum 5.9...
  9. K

    Rock Solid ram steering fix

    Hey everyone, I was reading about the steering fix that Rock Solid has. I tried to look it up in the search on this forum but only found a post by bigred318 in 2012 that didn't say if anyone had actually tried it. Is there anyone on the site that has done it? From all the reading that I have...
  10. K

    gauge cluster change out

    Hey folks, I tried searching the net and also the search function on here, but I was wondering on if anyone has tried to change out the cluster from mechanical/analog to the digital one? I do know it'd be a rather large undertaking to do to some degree or another. I was just wondering if it's...
  11. K

    5.9 crank no start issue

    Good evening folks, I'm writing to pick some brains about my crank no start issue. So far I have checked relays, wiring and avoiding the fuel pump like crazy. I tried to start it a few times but couldn't hear the fuel pump at all. But when I depressed the schrader valve on the fuel rail, I...
  12. K

    Axles question

    Good morning folks, I am looking to glean some info off the people in the know..... I have printed off the build sheet for my 1996 2500, and under the axle section for the front it says Dana M60/248MM Front Axle 4850 lbs. Would that mean it's a dana 60? And the rear says 200mm 6085 lbs. Would...
  13. K

    Evening everyone!

    New member here, and man you guys have put up so much information. It's almost too hard to do in a weeks sitting. Although I already was a dodge owner (2012 1500 sxt). I went and finally got the size of truck that I wanted in the first place. It's not new by any means lol. But it'll...

Latest posts

Staff online

Members online

... and 6 more.
Total: 1,439 (members: 56, guests: 1,383)
Robots: 1,887

Forum statistics

Threads
195,693
Posts
2,873,375
Members
156,567
Latest member
kayboz

Share this page

Top