Search results

  1. G

    crank sensor

    I just broke off the plastic that stuck out beyond the block and covered the hole with a metal plate. Dodge just stuck the sensor in there to plug the hole in the block.
  2. G

    crank sensor

    2001 Dodge 2500 4x4 Cummins 5.9l--Broke off the crank sensor flush with the engine block. Drilled a hole in it, run a small lag bolt into it, pulled on it and the lag just ripped a bigger hole in the plastic sensor. How do I get it out? thanks for ideas, gregjo1948
  3. G

    My truck is a quitter.

    Fuel pressure is 18psi. Check engine light is on and codes are P1693 and P 1698. Don't know what they mean or how to repair the problem. Engine still quits randomly.
  4. G

    My truck is a quitter.

    I know this is an old thread but I'll post anyway. The Fass pump starts running when the starter is engaged. The engine doesn't need to be started. If the starter is bumped and the key is left to "ignition on" position, the Fass lift pump will be running. I had the ECM rebuilt and the engine...
  5. G

    FRPS

    Is there fuel rail pressure sensor on a 2001 Dodge 2500 4x4 5.9L Cummins?
  6. G

    Spark

    Replaced the damper and the spark is gone.
  7. G

    Fuel Control Actuator

    2001 Dodge Ram 2500 4x4 5.9L Cummins 5 speed manual---Cant find fuel control actuator online. Does a 2001 Cummins use one? thanks gregjo1948
  8. G

    My truck is a quitter.

    I sent my computer out to be checked/tested/repaired. Will know today if that cured the quitting.
  9. G

    shut down

    2001 4x4 Dodge Ram 2500 Cummins 5.9L-5 speed manual tranny-At any rpm and any gear, it shuts down all cylinders. Sometimes it will catch itself and stay running. I think it's losing electric to the injection pump temporarily. Where does the pump get power and how would I check to see if it's t...
  10. G

    injection pump bleed

    2001 5.9L Cummins--removed injection pump and reinstalled--I need to know the correct procedure for bleeding the air from the pump and injector lines.
  11. G

    Spark

    2001 Dodge Ram 2500 Cummins diesel--Harmonic vibration damper bolted to the front end of the crankshaft has spark jumping to the edge of the oil pan. It's less than 1/4" between the two items and the spark is random, about 15-20 seconds apart while the engine is running at an idle. I'm thinking...
  12. G

    Fuel shutdown solenoid

    2001 Dodge Ram 2500 with Cummins diesel 5.9L. Is there a fuel shut-off solenoid on it and if so, where is it located?
  13. G

    My truck is a quitter.

    Do you know if there is a fuel shut-off solenoid? If there is, where is it? I 'm sure there is on the 1st generation, but I haven't found one on this 2nd generation.
  14. G

    My truck is a quitter.

    The lift pump will not run until the starter has been, at least momentarily, engaged. Turn the key until starter starts to crank and immediately release it and the pump will run. I believe that is an original factory set up. My problem is the Fass won't stay running. I checked the relay and it's...
  15. G

    My truck is a quitter.

    Would you know how the lift pump is powered? Does it go thru the computer or just the ignition. I do know it won't run until the engine has been cranked over so it is wired thru the starter somehow.
  16. G

    My truck is a quitter.

    Maybe when the lift pump stops running it takes a little time for the Vp44 to empty and when it does there's complete shutdown.
  17. G

    My truck is a quitter.

    I agree about not contamination--the lift pump isn't running continuously so I'll run a hot wire to it to verify that's the problem. If it is, I'll track down the reason for random power supply. Have you ever seen any Fass pump quit randomly when it has continuous power?
  18. G

    My truck is a quitter.

    I'm using the Titanium Fass 27707 lift pump and have installed new water/fuel separator filters. The engine will fire up and run at any rpms, but it will randomly quit. Does not skip on one-two-three cylinders. It drops all cylinders together and it is under any running condition, setting still...
  19. G

    2500 ram quits

    My 2001 2500 4x4 Ram quits randomly. Has 5.9 Cummins diesel and 5 speed manual tranny. Using a Titanium Fass 27707 lift pump with new fuel/water separator filters. The engine shuts down completely, randomly, and will start back up almost instantly. Does it any rpm, any speed, any gear, even...
  20. G

    My truck is a quitter.

    Engine has shut down in most conditions. From setting still at idle to 60mph at 1800rpm. Have not had a heavy load on the truck since this has started, just an empty box/bed.
  21. G

    My truck is a quitter.

    2001 2500 Ram with 5.9 Cummins diesel and 5 speed manual. Engine is randomly quitting. So far, it has restarted within one minute. I added a bottle of fuel treatment. I changed the fuel filter and water separator, and it still quits. When running, it's holding 18 psi fuel pressure. Could it be...
  22. G

    turbo

    I'm going to check closer for the whistle. I'm thinking it may be exhaust leaking past the exhaust brake.
  23. G

    turbo

    What/where is a dump valve?
  24. G

    Turbo/Exhaust Brake/??? Issue

    I have an exhaust brake on my 2001 5.9L with a manual trans. and it is on whenever I completely let off on the accelerator. It does not kill the engine.
  25. G

    turbo

    2001 with a 5.9L Cummins diesel. Strange whisling noise coming from exhaust. Could it be a sign that the turbo is failing? Never had a turbo fail so, I don't know what look/listen for. thanks, gregjo1948

Latest posts

Staff online

Members online

... and 7 more.
Total: 1,634 (members: 57, guests: 1,577)
Robots: 1,842

Forum statistics

Threads
195,636
Posts
2,872,786
Members
156,465
Latest member
KTMmarcus

Share this page

Top