Ok. i got it all figured out. I'm going to have to get some pins and wire up a few things. my truck didn't come with the connectors pinned out for that window. No biggie. I do this **** for a living. I got a hold of some schematics and found out how it's running and where it's getting it's power...
Thanks Jimmy! I ordered some male terminals for that connector assy.
I really appreciate your help. I should have everything i need to wire it up now.
I'm going too pre wire the window switch while i'm up in the headliner so all i have to do is hook up the window motor once i get it installed.
Cool! So looks like i just need to run wiring for 1,8 and 7. My ground and fused ignition are on the left side connector. Any idea where i might be able to purchase terminals? I assume you work for Ram since you have all these schematics.
Is power backlite the rear window? I think so, It shows - and + like it reverses polarity for a window motor. Probably need that "Fused B+" too for the window. I hate to keep bothing you. Can you find schematics too rear slider window?
Any chance you can find the pin out for that connector. Im gonna need to make a extended harness to reach down there at some point when i upgrade my back window too. I think i might just cut my connector in the truck since its only one wire in it. Extend that wire and then add the pins and wires...
Ok so i found the plug on the R/R c-pillar, and sure enough there is a connector there with a white/green wire in cavity 6. I bet that second plug was supposed to go down there. I'll have to find out how i can reroute that harness up there to come down now.
Hmmmm.... wondering if Im missing part of my harness in the roof.
I know i had two spare connectors i left up in the headliner. I know one went too the sunroof motor(which i don't have). Wasn't sure if the other one was maybe a over head DVD player.
Only two plugs i have plugged in from the...
Thanks. Ill check that when i get home tonight.
I also just noticed last night the small light in the console that lights up the cup holder area isn't on. It's just a simple two wire LED.
Wondering why it's not on? Any chance you know the schematics on that or how it's powered up? I would assume...
ok i found it. It goes into front a-pillar connector, cavitiy 2. I've got a wire on the other side too. So data line should be fine. I wonder if i have a bad HomeLink
Any idea where pin 3 (Lin Bus) goes? Front connector at A-pillar or back C pillar. I can then check the other side of that connector and see if i have a pin there.
id really like to see the connector end view for the HomeLink module.
Im thinking there might be a issue with the data link between the homelink and EVIC since i never get any message on the EVIC when i press the button. i know i have power because the homelink back lighting is on.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.