Recent content by jglass

  1. jglass

    Wade in channel vent visor

    I put the EGR version on mine, and they fit great. The wind noise is driving me crazy. I’m really considering pulling them back off.
  2. jglass

    What did you do with your 5th Gen this week?

    Just saw this in another post (I will try to find), and the dealership has to load the feature in.
  3. jglass

    2019 Problem & Fix Thread

    I noticed some cracks in my taillights, and got to inspecting them. Where the clear lens meets the red, they are cracking horizontally. It’s on both sides. I spoke to the dealership, and they looked at a couple others on the lot. They called me back and said they were having the same problems...
  4. jglass

    Interior mood lighting around glove box question

    There is a micro switch on the left side of the glove box. You’ll see it cut out a little different from the right, and it’s just over the edge with a rubber cap. The lid has a flat lip that contacts the switch to turn the interior light off. I thought I was have a problem with the light...
  5. jglass

    Upper glovebox defective?

    On my Longhorn there is a “light bar accent” on the outside top, between the door and dash board. I thought this was the same problem at first, then realized it was meant to be on. In the glove box on the left side, you will see a cut out for the piece of plastic on the lid that hits the micro...
  6. jglass

    What did you do with your 5th Gen this week?

    Removed the awful 4x4 stickers, and the longhorn badges from the side of the truck. Slowly removing chrome to find a good balance. Full detail getting her ready for an 800 mile trip to Gatlinburg. Used Chemical Guys leather conditioner for the first time, and I'm really impressed. Didn't leave...
  7. jglass

    Going for my first service and a laundry list of issues

    “Pop when turning on uneven surfaces (I know about the fix )” I have heard this too. What is the fix?
  8. jglass

    LED trouble

    I can draw one up. I wanted my switch to be able to turn on the lights when it was not in reverse. My goal was to have a light when I was skinning a deer or getting dressed to go to a treestand. I'll draw one up when I get home.
  9. jglass

    LED trouble

    Running a different ground helped some, by there was still some interference. So I ran directly to the battery + and - then used a relay off the reverse light wire, and that fixed it.
  10. jglass

    LED trouble

    The reverse and a constant + are going to the lights. Reverse goes directly to the lights +, and the constant + through a manual switch. I don't want one back feeding into the other when being used, so the triangle with the line is showing where I put my diodes.
  11. jglass

    LED trouble

    Here's a pic
  12. jglass

    LED trouble

    Mine is grounded to the frame. Also, I pulled the wire run loose and wrapped it in foil, and grounded the foil just to see if I was picking up any interference. Same thing. I'm going to run a direct wire to the battery tomorrow morning to see if that works. If it does, then I'll use a relay...
  13. jglass

    LED trouble

    Well it's not the ground.
  14. jglass

    LED trouble

    Ya the more I sit here thinking about it, the more I lean towards the ground.
  15. jglass

    LED trouble

    So I installed 2 18w 4" LED pods on the back of my 2013. I tied them into the trailer hitch wiring, and they work great. I put the truck in reverse they come on, I flip the manual switch they come on. All is well...until. Until I am backing up and look at my camera display, and it's all fuzzy...
See more

Latest posts

Staff online

Members online

... and 112 more.
Total: 1,789 (members: 162, guests: 1,627)
Robots: 1,774

Forum statistics

Threads
195,706
Posts
2,873,563
Members
156,587
Latest member
rtracy

Share this page

Top