Black1500Ram
- Posts
- 345
- Reaction score
- 484
Latest activity Postings About
-
-
Black1500Ram replied to the thread Bilstein 5100 @ .75" Setting.If you're doing Bilstein's all the way around, you could also throw a 1-1.5" coil spacer in the rear to maintain the rake and run 1.4"... -
Black1500Ram replied to the thread Lifter Failure / Hot Oil / Better Cooling etc..So welded at muffler shop they did a decent job but I had to Dremel the inside to get it back smooth. Sounds 90% better but it still...
-
Black1500Ram replied to the thread Lifter Failure / Hot Oil / Better Cooling etc..So update the afe headers I bought used have a big crack in them on the rear runner. It was not this visable when I first got them...
-
-
Black1500Ram replied to the thread Headers.Sent them an email asking what grade stainless - if i get a response i'll report back.
-
Black1500Ram replied to the thread 5th Gen hub swap?.Probably. I’m most like going to end up redrilling my stuf to 5x5… the rear axles make it cost prohibitive to got to 6 lug even if the...
-
Black1500Ram replied to the thread 5th Gen hub swap?.Not yet. I’m working on fixing this stupid afe header exhaust leak.
-
Black1500Ram replied to the thread Need jumper cable recommendations.I concur - I have 2 gauge cables now after helping someone jump their car with cheap 8 gauge ones. They got so hot I could barely touch...
-
For jumper cables, make sure that you get no less than #8 cables, #16 cables are the very worse cables #1 or #2 are used in welding...
-
Black1500Ram replied to the thread Lifter Failure / Hot Oil / Better Cooling etc..Welp ended up going with the sealer… still ticking / leaking away. Starting to think the drivers side header has a leak in the welds...
-
Black1500Ram replied to the thread Lifter Failure / Hot Oil / Better Cooling etc..Sooo I bought a small sheet of 0.025” copper that I’m just going to cut into strips the make a donut gasket out of. I’ll hammer the ends...
-
-
The amount of threads on this forum of screwed up cam swap is mind-blowing. OEM or Not. The Cam degree tool just determines whether or...
-
Black1500Ram replied to the thread Cam and lifter swap help.Hope OP doesn’t mind me asking: What’s the benefit of using a degree wheel when installing all oem parts? There’s no adjustable cam...
-
Black1500Ram replied to the thread MDS issues after cam and lifter swap.Possibly used a non mds cam or they put the mds lifters in the wrong spot on a few cylinders?
-
-
-
Loading…
-
Loading…
