rzr6-4's latest activity
-
Factory muffler was rusted out when I bought it so replaced it with a Speedway "high flow" a couple years ago, absolute garbage. Inlet... -
-
rzr6-4 replied to the thread Lowering rear and getting a better ride..Its really going to depends on what kind of miles you are driving. The major factors for energy consumption are wind resistance, rolling...
-
rzr6-4 replied to the thread Diff ratios.Are you sure its actually going into 6th? With my oversized tires I rarely make it to OD.
-
First off he wasn't replying to you. Second, brand new to forum, have contributed didiley squat so far, and then running tude on other...
-
rzr6-4 replied to the thread Lowering rear and getting a better ride..Adding weight is going to give you a noticeable hit in mileage for a minimal improvement in ride IMO. I'm with @mtnrider, air down and...
-
rzr6-4 replied to the thread Lowering rear and getting a better ride..The only way to soften the ride regarding the suspension itself would be to put weaker springs in, which will lower its ability to "haul...
-
rzr6-4 replied to the thread Considering a Hemi Powered 2500.Only person I know personally to have a lifter go was in a 5.3 chevy. If you like the truck get it and just deal with it should you be...
-
rzr6-4 replied to the thread Rear coil spring too stiff.Shocks can make a huge difference if they're old. What vehicle are you used to? A 2500 will never be as smooth as a 1500 or a car if...
-
rzr6-4 replied to the thread Bilstein 5100 and Factory 1" lift.Putting the shock in to the lowest setting and without the spacer will put you at normal, non lifted ride height. So if you remove the...
-
rzr6-4 replied to the thread Bilstein 5100 and Factory 1" lift.5100 setting + 1" spacer = total lift. It's definitely a different style of spacer compared to most but I don't know what else it would be.
-
rzr6-4 replied to the thread Throttle Control + 4WD Light + Coolant Low.If your coolant temp sensor on top of the water pump isn't plugged in / working, that will throw the throttle light. Add in your P2181...
-
rzr6-4 replied to the thread Consensus on 4" lift..Once again having to assume, if you have a 1500 you will need to get a diff drop kit, angle correcting control arms, etc but to my...
-
rzr6-4 replied to the thread Consensus on 4" lift..Assuming you are talking about cutting the fenders..... lifts don't require cutting, bigger tires do. If not talking about fenders...
-
rzr6-4 replied to the thread Demon swap into 1500 Ram "Li'l Rex".Bold move posting your name & address openly online but to each their own. Personal info aside, that will be a pretty sweet build once...
