Search results

  1. Zach Carlson

    Starts and dies

    Thanks for the info on that. I cleared the codes and ran it again. Codes didn't pop back up again. Runs great cold but stalls after I start getting temp. Need to go thru and verify I have no vacuum leaks. I believe that's what's stalling it out. I appreciate all the help and insight...
  2. Zach Carlson

    Starts and dies

    Update: Got it to start. My lifters on bank 2 weren't plunging properly. Took em out and worked them a little and reinstalled. Truck started and ran really well for several minutes. Then stalled out. Pulled p0016 code. Crank/cam misaligned and a couple vacuum codes. Fixed vacuum hoses...
  3. Zach Carlson

    Starts and dies

    What would cause cylinders 2,4,6,8 valves to not close at TDC? Leaking around intake and exhaust valves on all cylinders on passenger side. It leaks around all valves on either exhaust or compression stroke. Doesn't matter. I ripped the valve cover back off to verify everything was seated...
  4. Zach Carlson

    Starts and dies

    So did a leak down test. Driver side averaged 25% across the board. Heard leaking from oil fill cap, but was super faint. Nothing from throttle body or exhausy. Passenger side.....50-60% leaking from both intake and exhaust valves. I made sure each cylinder was top dead center before each...
  5. Zach Carlson

    Starts and dies

    I did use the push rods from their kit they offer. No auto store near me has a leak down test tool, just comprssion. When I hold the gas to the floor it starts sputtering like it wants to take off but doesn't. I will go buy a leak down tester and see if that's the case. TSP told me that...
  6. Zach Carlson

    Starts and dies

    I have eliminated the key fob as the issue. I have not swapped crank sensor yet. It did not start with stock tune either so I had a guy tune it for the cam, just a base one to get it running. As far as fuel pump relay goes, all I can find are fuses. No relay. Those are good also. I have a...
  7. Zach Carlson

    Starts and dies

    Yes. No codes at all. Wish it had one to throw me in the right direction.
  8. Zach Carlson

    Starts and dies

    Need help. Running a 2013 ram 1500 sport 5.7. Had lifter failure due to MDS so I replaced the cam with a TSP stage 2 cam, lifters, pushrods, and springs. Timing is good as I checked it 5-6 times before reassembly. New cam position sensor, new vvt solenoid, have fuel pressure, spark, and 125...
  9. Zach Carlson

    Check engine codes

    I swapped plugs and a new injector in cylinder 3. Swapped coil pack with cylinder 1. Drives perfect unless wide open throttle. Then starts shaking like an out of balanced wheel. Keeps that vibration going until I stop and clear the code. Making me think a valve also.. Thank you for the help.
  10. Zach Carlson

    Check engine codes

    I'm running a 2013 ram 1500 5.7. Mods include K&N cold air intake, 90mm throttle body, BBK shorty headers, muffler delete(factory cats and rear resonators still installed), and a diablosport predator 2, 91 octane can tune. I started getting a cylinder 3 misfire code. Code only comes up after...

Latest posts

Staff online

Members online

... and 18 more.
Total: 1,477 (members: 68, guests: 1,409)
Robots: 1,888

Forum statistics

Threads
195,691
Posts
2,873,348
Members
156,563
Latest member
RAMET

Share this page

Top