Search results

  1. S

    blueprints for 392 stroker

    Well stay tuned this fall Im sure I will be talking with you on this. Im ordering a ton of parts right now for after deployment I will be starting this :). I have heard that tapping into the signal wire for the 0-5v is best at the pedal so im sure that's exactly where I will be going for it...
  2. S

    Stand alone trans?

    Thanks for that info!!!! looking at it, I think looking at the ease of use and ease of wiring I will be going with the US Shift Quick 4. just hook right up into the RPM wire. and get ahold of a 2005 Dodge Ram 1500/2500 5.7L PCM with manual transmission.
  3. S

    blueprints for 392 stroker

    oh that's good to know about the speed sensor, so really all I need to do is connect the controllers RPM output to existing wiring and go off that. I have never flashed a pcm would I need to take it to a shop or what for that? That was kinda my though process was try to make a bracket to use...
  4. S

    blueprints for 392 stroker

    I have seen guys that have done swaps to different trans and their speedometer doesn't work anymore, what would I need to do to make sure my speedo still works fine. same with RPM?? If I bought a manual PCM would I have to get it flashed to match my VIN before I could start it up? if so, how do...
  5. S

    blueprints for 392 stroker

    I have a 2WD so that seems to save me a lot of headache. So essentially all I would need to do the swap is a: conversion adapter- https://transmissioncenter.net/shop/adapter-to-install-a-late-model-5-7l-dodge-hemi-to-4l80e-or-any-other-chevy-transmission/ A custom Driveshaft Custom...
  6. S

    blueprints for 392 stroker

    Charonblk07 if I got the 4L80E swapped in, bolted up. What would I do with my current PCM/TCM and the electrical connections from my stock harness? I have no problem getting everything bolted up and adapted, im at a loss for electrical
  7. S

    RPM Surge at highway speeds

    Kinda had the same deal, if you were to hammer down on the throttle doe sit slip or act up? mine did this... transmission shit the bed shortly after
  8. S

    Stand alone trans?

    So I am not completely positive on controllers, so if I went to a 4L80E I could use a controller and it would take care of my shifts entirely? What would I do with the connector that currently goes to my 545RFE? getting everything to work mechanically bolting up I have no problem with, my...
  9. S

    Stand alone trans?

    ST-8 can you possibly find it and post a link to it? I would like to pick the guys brain... I am trying to get the ball rolling on this so once I get back from deployment I can jam everything in and get my truck back on the road. and btw...Im on #6 545RFE!!!!! To the point I sent my truck to...
  10. S

    blueprints for 392 stroker

    whatever you plan to do with that transmission LET ME KNOW!!!!! I have burned six 545RFE and I'm only around 500HP but plan on getting a new engine from inertia to put 800+ out....so i gotta figure something out!
  11. S

    Stand alone trans?

    I have an 04 Ram 5.7L 2WD automatic, I have burned through so many 545RFE i have lost all faith in them! would it be hard to convert over to something else? Im not sure what i could/would go to but just seeing if anyone has any insight on it? I don't want to alter my truck into a manual...
  12. S

    Can I fit 37?

    It would LOOK like 37 wouldfit... until you turn! @@@.... you're good with 35 so just stick with that. 37 you need to go higher. Good luck!!!
  13. S

    Can I fit 37?

    Also I would talk to a 4 wheel store on spacing and such for wheels cause I run stock wheels but also have 2" spacers. If I didn't have those I would hit my control arms.... I know aftermarket wheels can cure that but I like my stock
  14. S

    Can I fit 37?

    I went ahead and went with 37".... you can fit a 35" with level up front. I have a 4" lift and I rub really hard with 37. I trimmed my running board back ( still looks stock) but when I turn I run hard on the front bumper. I thought about throwing 2" coil spacers in but found out with a short...
  15. S

    Can I fit 37?

    My lift has new coil springs in front, Bilstein 5100, 2 in rear block. It is the Rancho RS6579B Rancho kit. I don't want the cali lean look at all lol, but I also don't want a crappy ride...my tires are cupped a little in the rear so i bounce around like a fart in a skillet I am running stock...
  16. S

    Can I fit 37?

    I have an 06 Ram 2500 cummins mega cab. I put a Rancho 4" lift on it (4 front 2 in block rear. and was told that I can fit 35 inch tires. My question is, can I drop the 2 inch "leveling" spacers in the front and fit a 37 under there in the front? and if I can do that will that raise my front end...
  17. S

    5" vs 4" cat or turbo back?

    If I do a turbo back, will that throw codes for the O2 sensors since it essentially deletes the cats?
  18. S

    Tune help

    I guess i forgot about the predator form diablo..I have a trinity and no canned tunes come with it so i wrote diablo off lol...forgot about SC too
  19. S

    2007 Ram 1500 throttle issue

    Are you running any mods that would effect the throttle? I run nitrous on mine and these rams are finicky on their throttles, I had to literally install a wire the just ran right along with another wire but it had a resistor in it. I assume you are not....so I would definitely check to make sure...
  20. S

    02 sensor wiring

    do yourself a favor...go to the auto parts store, have them pull on off the shelf, take a picture and go put yours back together...may just as well be easier to get a new one...Rock auto is cheaper if you have time to wait
  21. S

    No oil pressure

    I say gasket but more likely o ring
  22. S

    No oil pressure

    Did you make sure to get the gasket/oring in there...without the proper vacuum it will just pull and spit out
  23. S

    Tune help

    Depends on what mods you have, if you are decently modded I would say a custom tune is in order. Contact Hemi Fever and he can set you up or there is a few more tuners on here if you search for them. If you are just looking for a quick tune type deal, hit up a bully dog tuner for box tunes that...
  24. S

    Will this setup work??

    Looks Like it will work just fine. Depends on what type of sound you are looking for. Also this will be running the "true dual" so you will need to purchase 2 mufflers. Just cut in and put your cats/mufflers wherever you see fit. I run a Super 44 on my 04 truck and I love the sound, it really...
  25. S

    5" vs 4" cat or turbo back?

    I don't plan to immediately upgrade the turbo, I'm just taking the silencer ring out of it lol... Ok I will go for the 4" in then. Turbo back huh?

Latest posts

Staff online

Members online

Total: 856 (members: 28, guests: 828)
Robots: 1,726

Forum statistics

Threads
195,697
Posts
2,873,401
Members
156,571
Latest member
Joey93

Share this page

Top