Search results

  1. Meatball12

    Front axle Dust covers?/U-Joint Recommendations

    The Set-up: So i've been away at work for the past few months. My Old man was be̶a̶t̶i̶n̶g̶ ̶t̶h̶e̶ ̶s̶h̶i̶t̶ ̶o̶u̶t̶ "Taking care" of my truck while I was away. Well the truck now needs a major front end overhaul. Ive already done the 98-99 HD steering upgrade and 2 new wheel bearings. I...
  2. Meatball12

    Vacuum canister location

    it's under the battery tray Sent from my SM-G950U using Tapatalk
  3. Meatball12

    What did you do to/with your second gen today?

    Shift Kit Day. Put in a TFOD-HD2 shift kit, adjusted the bands, New filter, and complete fluid flush. Gonna grease the front end tomorrow and pop in a new clockspring.
  4. Meatball12

    Factory Service Manuals

    DIY section. Its the second Sticky
  5. Meatball12

    Ride feels like crap

    Thanks for the input guys. I guess i never noticed the ride because i was always focused the sloppy steering, part of me thinks the slop in the track bar might have been masking some of the bumps. If yall say that the ride is normaly like that, ill take your word. Ill be upgrading the shocks in...
  6. Meatball12

    Ride feels like crap

    So I recently put a 2.5in leveling kit on. I got the truck an alignment and the shop told me my track bar had some play. I was planning on getting the adjustable upgrade soon but not immediately. On my way back from the alignment shop I experenced my first "Death wobble" incident, after I...
  7. Meatball12

    Steering column query

    That is what moves the gear indicator on your dash. The adjustment knob is so you can adjust it if the indicator is not aligning right. Sent from my SM-G930P using Tapatalk
  8. Meatball12

    What is this

    Upon furthur investigation, its hooked up to vacuum. So vacuum reservoir? Sent from my SM-G930P using Tapatalk
  9. Meatball12

    What is this

    Well it looks like it has a tube running to the gas tank. Im not trying to get covered in gas. So no, i have not opened them Sent from my SM-G930P using Tapatalk
  10. Meatball12

    What is this

    Please forgive my aparent stupidity but what is this? It is on the passenger side mounted to the frame. Sent from my SM-G930P using Tapatalk
  11. Meatball12

    Touch-Up Plastidip?

    Just respraying works fine. However, if you are one of those people that wants it PERFECT, get some protective gloves and a small cup of paint thinner. Dip your finger into the thinner and slowly massage the edges of the chip until you cannot feel the edge anymore, re-wetting your finger as...
  12. Meatball12

    "Driver Squib Circuit Short"

    i have my doubts that it is the clockspring. I replaced it this time last year and my horn and cruise control still work. However ill still check the wires for continuity.
  13. Meatball12

    "Driver Squib Circuit Short"

    So my airbag light has been on for a while and it has never thrown a code my OBDII scanner could read. I borrowed a Dealer level scanner from my old man's buddy. It came up with "Driver Squib Circuit Short" I'm at a loss.....WTF is a Squib. The Great Omnipotent Interwebs have been unable...
  14. Meatball12

    What did you do to/with your second gen today?

    Got my Xmas present installed after work today. New DeeZee brush guard. Pics to come soon. Now to shop for a nice big light bar to put on it.
  15. Meatball12

    Truck Randomly Died While Driving

    sounds similar to what happened to me few months ago. Ended up being my fuel pump.
  16. Meatball12

    Airbag light on. No Codes

    It was intermittent for about a week, but now its on all the time. I think I can rule out the Clockspring because the cruise comes on and horn works. I've jiggled the wires under the steering column with no result. Any thoughts on what to try next? I really have no idea what I'm doing when...
  17. Meatball12

    Heat problem

    Then check to make sure you are getting current to the plug. If you are then Congrats you have a bad motor. If there is no current at the plug, check it at the resistor block and control knob.
  18. Meatball12

    Heat problem

    if its not blowing at all then the first step is to check the fuses. If they are good then it could be either the resistor block or the motor. if the middle two fan settings don't work, but full blast does, then it is most likely the resistor block. best way to test the motor is to pull it...
  19. Meatball12

    Question about rear window?

    Its harder than you think. I have a solid rear window and wanted to go to a sliding. So I've done my research. The rear window is nearly impossible to remove at home. Its set in with a rigid foam/ epoxy stuff. your best bet is to get it professionally done. and it will be cheaper in the long run...
  20. Meatball12

    4.7 engine

    My brain hurts. First off, if you have coolant by the muffler......you have a magic truck. Second, if you want more help, pictures are worth 1000 words. and you need all the help you can get right now
  21. Meatball12

    Where do you mount your switches?

    had mine on the overhead consile until i built my custom center console Sent from my SM-G930P using Tapatalk
  22. Meatball12

    Harland Sharp RR. Are they really necessary?

    So I'm looking to improve the performance of my truck but I'm not trying to build and tune the shit out of it, so I'm having trouble justifying spending $400 dollars on rolling rockers to myself. Isn't there a Stamped steel alternative 1.7 rocker for our trucks.
  23. Meatball12

    99 Ram1500 5.9 Magnum

    Check your fuel pressure at the rail while running. You may have a kinked/ blocked fuel line.
  24. Meatball12

    Remote Start/ Key-less entry

    I agree. I'm only looking for remote start and unlock/lock. Yet most of the packages I come across have the panic button and trunk pop(super useful....). I don't want any of that BS.
  25. Meatball12

    Remote Start/ Key-less entry

    So ive been shopping around for a good combo remote start/entry system. It is a mixed bag as far as compatibility and quality. So I was wondering if anyone here has installed an aftermarket system and what their thoughts are as far as reliable brands, features, etc. any and all opinions are...

Latest posts

Members online

Total: 560 (members: 20, guests: 540)
Robots: 1,585

Forum statistics

Threads
195,622
Posts
2,872,655
Members
156,453
Latest member
Jems007

Share this page

Top