FlatLandRam
Member
Just wondering if anyone has ever cut out and replaced the factory y pipe with A stainless aftermarket one? I have installed a 3in/ 2.5in dual out on my 2014 ram but i feel like it should be flowing a bit better than it is.
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Wow, guess you read this post wrong, get your truck dyno tested before and after the y-pipe..... this is comparable to a newfie adding flame stickers to the side of his truck and saying its faster now.........[emoji23]An aftermarket Y-pipe is not going to show any noticable increase unless you are also adding headers. The stock Y is pinched off, but the stock exhaust manifolds just dont move enough air to really benefit much by opening up the y-pipe. I would hold off on this until you are ready to install headers.
this is comparable to a newfie adding flame stickers to the side of his truck and saying its faster now.........[emoji23]
All depend in how gullable you are or what you beleive[emoji91] [emoji91] [emoji91] [emoji91] [emoji28]So you're saying it isn't?!
ARH makes longtubes with or without cats for all the 2006-2016 Ram 2500 5.7 trucks
Do the ARH headers with cats bolt directly to the OEM flange at the Y, or is modification necessary?