ramthis9501
Senior Member
we're doing an engine swap out of a 96 ram into a 95. there are so many connectors! anyone know where all these go or where i could find a diagram or something of it? thanks
need help!
- Thread starter ramthis9501
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
KGBIGCOUNTRY
Senior Member
- Joined
- Jun 29, 2010
- Posts
- 13,309
- Reaction score
- 475
- Location
- MECH, VA
- Ram Year
- 2004 RCSB/2005 QCSB
- Engine
- 5.7 / 5.7
Man not sure but we just pulled my motor in mine and the harness will only go one way im guessing it would be the same general idea on yours. Are you sticking with the 318 or going to a 360 because that mmight throw a monket wrench into things.
OP
OP
ramthis9501
Senior Member
nope sticking to the 318
KGBIGCOUNTRY
Senior Member
- Joined
- Jun 29, 2010
- Posts
- 13,309
- Reaction score
- 475
- Location
- MECH, VA
- Ram Year
- 2004 RCSB/2005 QCSB
- Engine
- 5.7 / 5.7
If you can find a shop around that can print you up an All Data sheet you might be able to get by on it.
OklaHemi
Supporting Member
- Joined
- Jun 25, 2010
- Posts
- 4,254
- Reaction score
- 25
- Ram Year
- 04
- Engine
- new age hemi
What are you doing Colton?
Bigtman07
Registered User
- Joined
- Jun 28, 2010
- Posts
- 9,329
- Reaction score
- 287
- Location
- Piqua, Ohio
- Ram Year
- 2000
- Engine
- Cummins 5.9
Did you happen to check the service manual in the DIY section? It may have some answers for you. I know it says 2001 but it is all the same for 2nd gens back to at least 97.
I'm not sure if that system is obd 1 or 2. I know 2 has more wires and sensors but I can't remember when the change over happened. But I agree with KG usually the harness only goes in one way. I have the 360 but if ya need some pics of the engine bay to get some sort of idea let me know. I'll be happy to take some.
I'm not sure if that system is obd 1 or 2. I know 2 has more wires and sensors but I can't remember when the change over happened. But I agree with KG usually the harness only goes in one way. I have the 360 but if ya need some pics of the engine bay to get some sort of idea let me know. I'll be happy to take some.
Last edited:
OP
OP
ramthis9501
Senior Member
thanks KG i'll try to get a data sheet. Big T thanks i'll let you know if i need some pics. and mike we're doing an engine swap for my uncle, i told you a while back
