C6Pilot
Junior Member
- Joined
- Jun 6, 2015
- Posts
- 24
- Reaction score
- 6
- Ram Year
- 2013
- Engine
- Hemi 5.7
I just installed the OEM backup camera kit Part # 82214240 in my 2013 1500 Sport w/8.4AN. I had the dealer flash the XAC code before I did the install. I completed everything EXCEPT I could not figure out how to gain access to the BCM C5 connector to attach the last purple wire to pin 45.
Since it was getting late I buttoned everything up and started the truck. The camera functions perfectly but there are no Active Guidance lines overlayed on the video and there is no option in the setup menu either. The only option listed is "Parkview backup camera delay". There is no "Parkview backup camera Active Guidelines" listed as an option.
Does pin 45/purple wire control the guidelines? Will the guideline option in the setup menu show up once I connect the purple wire?
Any advice or pictures for dealing with the C5 connector on the BCM would be greatly appreciated.
Since it was getting late I buttoned everything up and started the truck. The camera functions perfectly but there are no Active Guidance lines overlayed on the video and there is no option in the setup menu either. The only option listed is "Parkview backup camera delay". There is no "Parkview backup camera Active Guidelines" listed as an option.
Does pin 45/purple wire control the guidelines? Will the guideline option in the setup menu show up once I connect the purple wire?
Any advice or pictures for dealing with the C5 connector on the BCM would be greatly appreciated.