Recent content by 66fryder
-
6
No Power to Fuel Pump
Thanks for your help. After much wire tracing, it appears the issue was in the ignition switch. Installed new switch and BAM... we have the HEMI growling as she should be!!!- 66fryder
- Post #7
- Forum: Engine & Performance
-
6
No Power to Fuel Pump
Jumper leads, 12 volt power source and ohm meter. Connect first lead from 12v positive to relay spade 85 & other lead from 12v negative to spade 86. Relay should click. With leads in place & ohm meter on continuity mode touch spades 30 & 87 with meter leads.- 66fryder
- Post #3
- Forum: Engine & Performance
-
6
No Power to Fuel Pump
Hey all, Here is my problem. 2004 Dodge Ram 1500 5.7 HEMI... No power to the fuel pump. Fuel pump is new, tested and is good. Relays have been tested and are fine, they also click when key is turned on. Fuse is good as well. New crank sensor. Ground at tank has been checked and ruled out...- 66fryder
- Thread
- Replies: 7
- Forum: Engine & Performance
-
6
No Power to Fuel Pump
No power to fuel pump 2004 RAM 1500 5.7 List of what I have done so far: Used a jumper from battery to pump and verified pump runs... Confirmed a ground at pump... Performed continuity test on power wire to the fuel pump from fuse block all good... Paperclip jumper where fuel pump relay is on...- 66fryder
- Thread
- Replies: 1
- Forum: 3rd Gen DIY
Members online
- DAK2
- Ludville1
- Kfield
- ric221
- vrbryan
- Kingjd123
- Murphy Slaw
- huntergreen
- RamDiver
- U&A
- drtumolo
- Racer9
- CountryboyNC
- Warlock656
- MOPAR78
- hallguy
- mb33458
- KalboKalbs
- RebelDad
- 55f250
- PrinceLtrain
- nlambert182
- RickeyB
- jabartram
- Cummins diesel
- ameldorf
- Artschool3
- 6speed4.7
- RKnea
- tattoosbylance
- richoy
- RJL1
- SilverLimited
- gunner_herman
- hwood
- DannyDang78
- crazzywolfie
- WSix
- samsdad02
- Audiowriter
- Westwind1124a
- chaosh1
- Ripemdry