Recent content by [email protected]
-
B
89 d150 runninag and starting probs
truck is a 3.9l v6. Ran fine up until a week ago. Noticed some bogging down when leaving from a stop. I thought it would be a good idea to try a msd coil. This did not help. The problem got worse. I also noticed the coil arcing out. I have no idea what that's about. so Back on with the old coil...- [email protected]
- Thread
- Replies: 7
- Forum: Engine & Performance
-
B
resistor block????
I had to remove the ac lines and blower moter under the dash due to the drain line being broken and leaking on the floor. As it came away a thin metal wire leading from the top of the evaporator coil to an electrical part that the chiltons manual calls the "resistor block". Does the thin...- [email protected]
- Thread
- Replies: 1
- Forum: Audio & Electronics
-
B
New Member, Hello
I just noticed a typo in my first post. The one in the yard is a 1991, and as it turns out they are slightly longer so i'll just work on getting the ones that are on there as clean as possible. So I do have a set for a 91 if any needs them.- [email protected]
- Post #9
- Forum: General Discussions
-
B
New Member, Hello
Thanks guys, The reason i asked about the injectors was that new ones are like over a $100 a piece.. Where does one buy rebuilt from?? I'm headed back to the junk yard today but mostly for interior stuff. Later- [email protected]
- Post #7
- Forum: General Discussions
-
B
New Member, Hello
Hi all, Just bought a 1989 d150 with a 3.9l. Had 69,000, now 70,00 miles on it. Everything on looks original. Its been fun to work on so far. We have a few junkyards nearby but there wasn't much there until Friday an 89 d150 with a 318 showed up in one. I'll be pulling as much as i can get...- [email protected]
- Thread
- Replies: 8
- Forum: General Discussions
