I used this website, https://techauthorityonlinedemo.extra.chrysler.com/service/repair/wiring/view/classic.htm#
If you look up the LIN BUS Systems, and follow the diagram for the LIN BUS CBC 3 wire (OR/DB) that leaves from pin #45 in plug C5 on the BCM it shows it going to the rear of the cab...
I installed the same oem backup camera kit ( 82214240 )last fall. The majority of the install was a breeze but I also found it very difficult to tap the purple wire into the wire coming out of pin # 45 on the BCM. So with that being said I ended up extending the purple wire and tapped into it...
The install wasn't bad at all, I am about a 7 out of 10 on the mechanically inclined scale and it only took about 2 1/2 hours for me to do myself. If you have any specific questions just send me a message.
Hello Jeepguy, I was asking you which harness to order from you a while back. Now I think I am ready to go ahead and do the upgrade. Attached is a pic of the male side of the body harness by LF wheel, and male side of plug by ebrake in cab. Any help would be appriceated.
Thanks
Can anybody confirm that this works with the uconnect 5.0 or do you have to have the 8.4? I also have the six speed tranny? I would love to do this upgrade.
Texting now no longer working.
I have a samsung galaxie S3, and when I fist bought my truck in Dec of 2013 I paired my phone with the Uconnect 5.0 and everything worked great, even the texting. When I recieved a txt it would read it to me. Now after the dealer failed to update my radio properly...
uconnect 5.0 update help????
Hello, I just went to my local dealer yesterday with a functioning u connect 5.0 system and they attempted to do the new update and now I have NO radio at all. They tried a few times and it kept failing. In Canada you can not access the software update on the u...
Thanks, I have tried to reset the radio to "factory settings" but it does not seem to do anything, all of my channel presets and bluetooth settings remain unchanged.
I have a quick question about the behavior of the radio in my 2014 Ram with a u_connect 5.0. Everytime I shut off my truck with the SXM (sat. radio) on, when I return and start the truck again it always goes back to SXM channel 1 ( the preview channel). Not a real big deal but it is quite...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.