Recent content by DTECH
-
D
Srt10 wheels 22 & shock replacement help
bilstein 4600 shocks can get them from eshocks.com...If you were closer I would sell you the black srt22s I have sitting in my garage... -
D
lift recommendation
2wd or 4wd...with 4wd you can use the bilstiens listed above...with a 2wd you can do a spacer for 1"to 2" or spindles for 4.5"...like maxtrac.. -
D
Engine swap
depends on the year magnum...the 05 motor will not have mds like the 06 hemis do..but if you don't mind it then all you have to do is swap timing covers, intake manifold, oil pan and a few other thing...you pretty much just need the stripped long block and put the car stuff on it... -
D
dodge ram broke rod or engine is locked up?? Help!!!
not sure where you located but a guy on Lxforums is selling a brand new original never run truck motor for $1600 he's in Ohio.. New mopar 5.7 hemi long block- DTECH
- Post #20
- Forum: Engine & Performance
-
D
dodge ram broke rod or engine is locked up?? Help!!!
pull the motor then pull the head..you will probably see the intake valve seat gone or the valve beat to hell because you had a spring break..but since you have an 06 Im sure you dropped a seat...- DTECH
- Post #19
- Forum: Engine & Performance
-
D
2006 ram 1500 hemi engine clunking /clanking
probably dropped a valve seat and all you hear is a bang when the piston slams the seat material into the head...- DTECH
- Post #4
- Forum: Engine & Performance
-
D
dodge ram broke rod or engine is locked up?? Help!!!
its tight but if its a valve train I would want to check that first..start with the plugs there should def be some damage on them if its a valve seat..if you can get your hands on a bore scope to look down the plug hole can help..- DTECH
- Post #17
- Forum: Engine & Performance
-
D
dodge ram broke rod or engine is locked up?? Help!!!
Pull the plugs if no signs of damge pull the valve covers and look at each spring and rocker arm...look to see if a spring is sitting higher than the others..this would indicate a dropped seat...a broken spring will be obvious as it would be collapsed....try to rotate the motor clockwise and...- DTECH
- Post #15
- Forum: Engine & Performance
-
D
dodge ram broke rod or engine is locked up?? Help!!!
If you just got done driving the truck and stopped real quick then went to restart and heard banging then you dropped a valve seat...pull the plugs and see which ones look busted...would almost bet it is going to be passengers side head 2nd cylinder from the front that dropped..you can get a...- DTECH
- Post #13
- Forum: Engine & Performance
-
D
Firestone airbag setup
Can u send me a part number for the air kit and bags -
D
Headers, T-1000, spohn bars
What year ram will the trinity work with...? -
D
Looking for tips on running my subs.
the amp can ground using the bolts that hold the seat frame down..just makes sure you sand away any paint on the surface to allow clean contact with the ground..- DTECH
- Post #6
- Forum: Audio & Electronics
-
D
Black SRT 22's
may rub the upper control arm at full lock if there 22x10" but other than that no issues.. -
D
Metal on Metal grinding sound
sounds like exhaust rattle...at certain engine frequencies it will cause the exhaust to resonate any parts that may be loose or rubbing against. I had the same issue at low acceleration when I installed a new system..as the some systems break in they may move out of alignment or clamps become...- DTECH
- Post #7
- Forum: Engine & Performance
