Thank you everyone for the good information. Lets now try again. If you were going to tap into the factory harness for a marine grade accessory outlet that will carry max 15 amps and be protected from the weather under a tonneau in the drivers side rear corner of the bed, where and what wire...
I am looking to add a 12V accessory socket in the bed just to the left of the tailgate at the rear drivers side corner. Where is the best place to tap into the harness for 12V? I anticipate a max of 15 amps draw from this socket.
Just wanted to update this thread as to what I did and what were my results. I changed the transmission fluid by dropping the pan and changing the trans cooler. I did not power flush, or run the engine to flush out every last ounce of fluid. I did let the fluid drain overnight. While I was in...
Thanks for your input Core Lokt, I did try dash commander with no luck. I then went ahead and purchased the pro torque app just to give it a try and after some configuration changes and loading of extra scrips, I was able to get Trans temp from my ELM Bluetooth adapter and the torque pro app...
I ran about 200 miles on NJ highways last night. The "Polar Vortex" wind was fierce. My problem is definitely the seal in the upper frame of the door. I found myself grabbing the upper part of the window frame and pulling it in by hand to stop the noise. As long as I was pulling in with a...
I am looking to monitor trans temps in a all digital fashion from something like a tablet connected to an ODBII Bluetooth sensor. Is this possible? I tried it via the free version of the torque app and I could not find the trans temp listed as a data item. Is this available as data in an 07...
Quite bit more than I originally planned.
Thanks SiverStreak! Still need to finish it off and buff it out too. While I am here can you tell me more about you Trans temp gauge modification? That is what I want to do next as I am planning a 1400 mile tow of 7.5K high wind resistance load...
I got it pretty much finished. Just need now fog lights, one step bar and new set of rubber. Been looking for a new set of ram take offs but have not found the right deal yet. I ended up using all brand new stock suspension and steering components for front end got lucky enough to find an...
I was just replying to another guy about this so I will post here too. Take a look at this excellent video and see if this is your problem with that joint. It seems to be pretty common.
https://www.youtube.com/watch?v=kPze_fn6c4g&t=699s
Thank you for your effort. I ended up purchasing the PBT fender and putting on my PB7 truck. While I still dont have an answer to why, Everyone should be happy to know It matched perfect. You cannot tell the difference. Hope this helps someone in the future.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.