Well truck is back from hospital, just in time to be traded off I think,lol. It took a TB and a new pcm controller, along with cleaning the pcm connector terminals. May be going for a 2019 ram 1500 bighorn.
I did try that relearn but I'll do it one more time. When I tried it last time it started flashing the lightning bolt icon and electronic throttle control fault. Hope this comes around or it's bye bye ram.
My 2013 Ram 1500 has the dreaded electronic throttle control fault with transmission in limp mode/4th gear, reverse, neutral, park only, also has a trans ‘a’ solenoid fault that didn’t appear until the throttle fault happened. I bought an accelerator pedal and throttle body by recommendations of...
Magz, Where did you mount the compressor? I want to mount mine under the hood, on the firewall behind the battery. Airlift says to not mount it under the hood but I don't see why it would hurt. At least it would be protected from water spray and grime.
ok long story short. Reason for two-step upgrade was I had bought a different cluster and it ended up not working with my tire pressure monitor so swapped it with an Ra3 radio.this was after I had bought the 5.0 radio so I will be selling my 5.0 after I get upgrade parts to install Bluetooth mic...
I just read this whole thread and still no answer to my question. I am upgrading my radio from a 3.0 originally to a 5.0 and finally to a 8.4 ra3. What do I need to buy other than the mirror to add my bluetooth mic?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.