Recent content by Rusted1984

  1. R

    Couple questions regarding Emissions and AC

    How much can I expect to pay for a junk yard 360?
  2. R

    Couple questions regarding Emissions and AC

    Great info! Could I just grab a flex plate off of the donor vehicle that had a 360 in it? or am I forced to buy an aftermarket one?
  3. R

    Couple questions regarding Emissions and AC

    I did some research and see what you mean now, I don't know what the formula a person would need to figure out how big the relay will need to be. I'm currently searching for a 360 to swap for some easier power gains... I decided it will just be flat easier. How hard was pulling out your dash?
  4. R

    Couple questions regarding Emissions and AC

    Well I was thinking something in this range Push Button Start Kit Ignition Engine Starter Igniter : Amazon.com : Automotive It's 30 amps.. As far as performance goes, I would like to end at the 300 hp mark eventually.. I'm thinking it will need to be rebuilt but 302 heads seem to be...
  5. R

    Couple questions regarding Emissions and AC

    Electrical is my weak area... Would you know the correct amperage? I'm not worried about it getting stolen, I live 20 miles away from any other form of human life and I plan to shave the handles and use door poppers but I do appreciate your concern. I would also like to find 302 head but...
  6. R

    Couple questions regarding Emissions and AC

    Well I think it would a giant pain in the rear to fix. What I think is the ignition box or controller: the rod I pull on the left side of the column to start the truck runs into this box approx the size a pack of cigarettes, with 6-8 wires coming out of it going to somewhere important I'm sure...
  7. R

    Couple questions regarding Emissions and AC

    This is exactly what I would like to do, I was a little afraid the 1st gen sub forum was dead! It is a 2wd and then engine bay is a mess with vacuum lines, I would like to eliminate as much clutter as possible without risking any reliability issues. Also..are you familiar with the old...
  8. R

    Couple questions regarding Emissions and AC

    I was wondering if any one knew if a walk through or guide on removing emissions equipment from a 1st gen ram with a 318. I live in an area that does not require emissions and this will mainly be an off road vehicle only. I'm not quite sure what hoses/parts etc can removed safely without any...
Top