Recent content by SilverStreak88
-
How often do you check your catch can? Stock air box a CIA?
Where'd you get them valve covers?- SilverStreak88
- Post #16
- Forum: Engine & Performance
-
3500 Single Cab Dually? Oh yeah!
I think a 2" drop all the way around on 22 fives and lots of Cummins hop up's would be sweet. Or, just do it like this little guy...https://youtu.be/o6YVEkl5pbs- SilverStreak88
- Post #16
- Forum: General Discussions
-
Anyone running MOOG UCAs?
Yeah, they've been good. I still wanna go with the Zone kit when i come up with $1100- SilverStreak88
- Post #7
- Forum: Lifted
-
-
Wheel bearing replacement q
I don't use an FSM so I don't know what steps are in there. I do have hands on experience with it though and if can get those bolts out without pull the axle, nuckel and tiered end I would like to know. I don't see anyway to fit a torque wrench in there without do those things .- SilverStreak88
- Post #37
- Forum: Exterior
-
Windshield drain holes?
As long as it's clean under you should be good, you can look before you put it back and see up by the windshield where the water goes. If you look between the rear top of the fender and either side of the firewall you will that it's pretty much strait down.- SilverStreak88
- Post #5
- Forum: Exterior
-
Windshield drain holes?
It drains from the sides, it's formed into a crown like the highways to allow water runoff.- SilverStreak88
- Post #3
- Forum: Exterior
-
Wheel bearing replacement q
The axle has to pulled mostly out of the hub to access the top and front hub bolt, I only did my hubs in a parking lot last week so...- SilverStreak88
- Post #35
- Forum: Exterior
-
Wheel bearing replacement q
You have to separate the upper control arm from spindle and the tie rod end.- SilverStreak88
- Post #33
- Forum: Exterior
-
3rd Gen Ram "Pre-Runner" Appearance Budget Build
Well, not real lockers, but those will do. I'm just tired of seeing 20's and like to see more tire. The 17's will ride and perform better than 20's anyway.- SilverStreak88
- Post #13
- Forum: Member Trucks
-
3rd Gen Ram "Pre-Runner" Appearance Budget Build
What size are you going to run? Hopefully not 20's and some sweet ass "real" beadlockers.- SilverStreak88
- Post #11
- Forum: Member Trucks
-
3rd Gen Ram "Pre-Runner" Appearance Budget Build
Sweet! I'm subbed- SilverStreak88
- Post #9
- Forum: Member Trucks
-
Which A/C Door needs replaced?
Okay, it'll be 2 doors tied together, you have to pull the dash, as you probably already know. They're in the top of the HVAC box behind the radio.- SilverStreak88
- Post #4
- Forum: Engine & Performance
-
Which A/C Door needs replaced?
Do you have dual climate control?- SilverStreak88
- Post #2
- Forum: Engine & Performance
-
Getting it murdered out, what everyone think?
By the title, one that's knowledgeable would think that you're moving to L.A. or Chicago. Anywho... the gunmetal gray and black are an awesome color combo, my favorite other than the blue and black.- SilverStreak88
- Post #27
- Forum: Exterior
