Recent content by Zervun

  1. Z

    Any tips on replacing window gaskets?

    Thanks guys, I'm assuming that just rolling down the windows is enough? Do I have to take the window out? I'm also assuming I have to pop the door panel off
  2. Z

    Any tips on replacing window gaskets?

    So on my 2001 Dodge quad cab the front window felt/seals are deteriorating and getting some light mold on them. So I purchased some replacements from LMC because I want to get my front windows tinted soon. I tried searching but couldn't find anything - I'm looking for advice on how to get...
  3. Z

    A/C trouble shooting

    See my thread here - I fixed my AC it was the diode and not the clutch http://www.ramforum.com/f62/ac_fuse_blowing_truck_running_rough_when_one-104159/ Not sure if that is yours but it's a ultra cheap and fairly easy fix
  4. Z

    AC fuse blowing, truck running rough when one is in

    Ok so I fixed my issues. For the idle/surging issues it was the TPS for the revving/surging and probably also the IAT (for the idle issue) For the A/C: Mine was the diode. When I had put the old battery back in I heard clicking and, it shorted out a few things, and this was one of...
  5. Z

    TPS issues?

    Well, the IAT could have been might my idle issue who knows. Ya mine didn't jerk so to speak, I would be going along and if I slightly gave it gas (or sometimes more gas) it would do a slight jump in RPMs then catch again. If I gave it full throttle it never did it. After I replaced the TPS all...
  6. Z

    TPS issues?

    I just replaced my TPS and IAT with ones from Napa. I believe one was Napa's brand and the other delhi or whatever it was. I had idle issues where it was jumping up and down as well as surging driving it. It fixed it.
  7. Z

    A/C trouble shooting

    I'm having A/C issues as well (it stopped working when I replaced battery - old battery I could hear clicking). I think mine is either the clutch or the diode. You might want to google those. You can get the clutch off of ebay (it is not that simple of a fix and need some special tools). The...
  8. Z

    Plenum Intake plate time?

    Good point - that obviously makes sense "idle air control". I replaced both in any case as they were fairly cheap and I was pulling off the throttle body. What was odd was under load/flooring it, it didn't surge, it was always when I was lighter on the gas. The PCV hadn't probably been...
  9. Z

    idle problems

    Can see my thread here http://www.ramforum.com/f61/plenum_intake_plate_time-104654/ Yours sounds like more of a plenum issue however I thought that was mine as well. Does need to be replaced but the IAC I think was the one that fixed mine. If your RPMs bounce and you have surging the IAC might...
  10. Z

    Plenum Intake plate time?

    Just a follow up - my idle/surging issues are fixed (have not done the plenum yet) - and yes you are right all plugs were clean as a whistle I did: TPS replacement - note the TPS actually looked fine but replaced it anyway, the two little knobs inside were not broken at all, which makes me...
  11. Z

    Plenum Intake plate time?

    Hello everyone, In a nutshell, about a couple months ago my truck started running rough. Surging every once in a while and idle jumping - some minor times it works perfectly. I hit the forums and researched and think it's probably a plenum gasket going bad. Today I am replacing the TPS and...
  12. Z

    AC fuse blowing, truck running rough when one is in

    So - sorry for the late reply didn't have a chance until yesterday to work on things. I did unplug the clutch wire - I'm assuming it was the one that comes from the AC compressor and shortly runs down the top of the valve cover. It did not blow the AC clutch fuse after that. Also, if I...
  13. Z

    AC fuse blowing, truck running rough when one is in

    Tried searching many times but the search doesn't allow "AC" as it is too common/short. I wasn't sure to post this in electrical or engine. First post but been a lurker for a long time - first issue I have had with this beast. In a nutshell: 2001 Dodge Ram 2500 5.9 66k miles (yes that is...
See more

Latest posts

Members online

... and 9 more.
Total: 1,403 (members: 59, guests: 1,344)
Robots: 1,465

Forum statistics

Threads
195,874
Posts
2,875,339
Members
156,856
Latest member
johnbruin

Share this page

Top