Search results
-
K
Bleeding Clutch
So before I had purchased the master cylinder seperate I didn't know you should buy the full pre bled system. Now I'm in the spot I am at now. How do you bleed this thing? I did it with the method on YouTube with the vice pumping the slave til no air came out. Hooked it all back up and blew...- K.Adkins_22
- Thread
- Replies: 2
- Forum: Engine & Performance
-
K
Clutch isn't going in all the way
My 01 5 speed is having troubles. When I push the clutch in its not going in all the way even when it's to the floor. Truck doesn't want to start or shift when it happens. Does that sound like slave/master cylinder to you all? Sent from my treestand- K.Adkins_22
- Thread
- Replies: 3
- Forum: Engine & Performance
-
K
Engine swap questions
I blew the engine on my 01 1500 5.2 5 speed. I'm goin to put a new one in it and was thinking a 5.9. What all would I need to make sure I got along with the engine that would be different and need swapped? Also I found a 5.2 out of a 98 jeep Cherokee. Would it be the same as the 5.2 I have now...- K.Adkins_22
- Thread
- Replies: 0
- Forum: Engine & Performance
-
K
Diagnostic Codes
Got p0037 and P0138. Looked them up and know they are O2 sensors but not sure what I need to do. Do they need changed or something else. Realized theres a lot of O2 sensor codes Sent from my treestand- K.Adkins_22
- Thread
- Replies: 4
- Forum: Tech Info
-
K
5.2 won't spark
Had the truck for about a month now. Had this problem one other time when in the mud but it dried out for about 10 mins and started right up. Today I went to start it (been raining and snowing all day) and it won't spark. It cranks though. Am I right in assuming its the ignition coil? Last time...- K.Adkins_22
- Thread
- Replies: 2
- Forum: Engine & Performance
-
K
Removing chrome sticker from grille
I recently got an 01 Dodge 1500. It's a red truck and I've always liked the red and black look over the chrome. So I started peeling the sticker off my grille to get to the plastic underneath to paint black and man is it hard on your fingers. Was wondering if anyone has found a better way that...- K.Adkins_22
- Thread
- Replies: 1
- Forum: Exterior
