Search results
-
0
help with Sway bar quick disconnect
QD swaybar I understand, thank you sir. I found that tough country makes a QD endlinks setup that will work for a 1500 ram 4x4 that has been lifted within my range, I just wasn't sure if anyone on the forum had came up with a better way to disconnect or if there was any feedback on one specific... -
0
help with Sway bar quick disconnect
QD swaybar I was pretty sure that 01 rams only came with a sway bar in the front and yes the truck is 4x4, it's an ORE, my bad for the lack of information. I understand that jeep stuff might work, that's what I was getting at, wasn't sure about the actual geometry of the matter. If it's all the... -
0
help with Sway bar quick disconnect
Hey, I have an 01 ram 1500 with a 5 inch lift and I was wondering if anyone makes a swaybar quick disconnect, either full bar aftermarket, or just quick disconnect endlinks. I was curious if there is a system that works specifically for a 98-01 ram or if anyone has a easy to make DIY system that... -
0
01 ORE ram 1500 lift help
Math... haha I picked up what you were putting down though -
0
01 ORE ram 1500 lift help
Who sells a good 7 inch lift kit that you don't have to cut up the truck to make it work? I see a lot of kits that say some cutting and welding required. -
0
01 ORE ram 1500 lift help
Okay so worst case senario I need to buy the 5 inch to see any difference. Thank all of you very much for the input and enlightenment I appreciate the hell out of it -
0
01 ORE ram 1500 lift help
I was going to buy the 5 inch lift kit if it wasn't going to raise the truck more then an inch. I don't have a problem spending the money, just didn't want to buy a kit that wouldn't work because all of them that are less then $1800 say they won't fit the off road edition. I don't know the truth... -
0
01 ORE ram 1500 lift help
Hey I'm new to this form I have an 01 ram 1500 sport Off road Edition on 33's. I was going to purchase a 3" lift from rough country lift for it, but after doing some reading, I knew that the ORE had a factory lift of what I have read is 1.75 inches. I wasn't sure if it would be a waste of money...
