Search results
-
5.9 sensors
I cant seem to find a complete list, does anyone have a list of ALL the engine, intake, vacuum, and exhaust sensors that are factory installed on a 94 ram 1500 5.9 engine? I'm going through the truck and getting it as close to brand new engine and electrical system wise as possible.- 94ram1500
- Thread
- Replies: 1
- Forum: Engine & Performance
-
vapor canister vent solenoid
Hello, does anyone know the correct name of the rubber connector that connects the vacuum lines to the vapor canister purge solinoid is called? connects to the solenoid in enclosed photo. I'm having a lot of trouble tracking down the part. thanks. PS where can I buy a obd 1 code reader?- 94ram1500
- Thread
- Replies: 1
- Forum: Engine & Performance
-
map vacuum line
Hello, is the map sensor on a 94 1500 5.9 gas engine calibrated to a specific vacuum line size/tube or will universal hose work?- 94ram1500
- Thread
- Replies: 4
- Forum: Engine & Performance
-
Helicoil for thermostat housing
I stripped the bolt hole on the thermostat housing, do I have to buy a specific size helicoil insert to fit the factory bolt or does the repair kit have an assortment of coils? Thank you- 94ram1500
- Thread
- Replies: 3
- Forum: General Discussion
-
Mystery stalling
my 94 5.9 1500 stalls out after a few miles, no sputter, bucking, just stalls like you turned it off. it cranks but wont start, I tried starting fluid in the tb, still didn't start so i doubt its the fuel pump. it will fire right up the next day after it sits, it runs like new, plenty of power...- 94ram1500
- Thread
- Replies: 6
- Forum: Engine & Performance
-
4:56 gears
I picked up a used ring and pinion complete unit with the trac loc lsd bolted on. one of the gear teeth looks worn down, it's not broken off or galled, the pinion looks fine, no damage there, aLso some of the teeth have polished spots on them, is the ring gear still usable...- 94ram1500
- Thread
- Replies: 9
- Forum: Engine & Performance
-
parts interchange
will the steering knuckles, drag link, tie rod, track bar, interchange on 1994 ram 1500/2500/3500's? -
aal geometry
question, I have an old set of leaf springs off a 70 charger that are in very good condition, if they are the same width and the pin holes match up, could I use them as donors for an add a leaf? thank you -
ecm
has anybody experienced this? I disconnected the battery in the truck for an hour and after I reconnected, the truck seemed to have more pick up and runs better than ever, I thought the od was off it runs that good. (od works just fine)when I turn the od off it downshifts a little snappier and...- 94ram1500
- Thread
- Replies: 5
- Forum: Engine & Performance
-
Overdrive shorting, sparks fly?
I'm afraid there is a short. I'm embarrassed to post this... this is to double check...on a 94 ram 1500, is the indicator light on or off when the trans is in overdrive? Also the O.D. is always on when the truck is started until you manually turn it off, correct? The 4wd indicator light...- 94ram1500
- Thread
- Replies: 4
- Forum: Audio & Electronics
-
higher flow injectors
does anyone know if they make an updated injector that can supply more fuel for a warmed up 1994 5.9? I'm talking 300 hp- 94ram1500
- Thread
- Replies: 2
- Forum: Engine & Performance
-
radiators, heat, and towing
I need a few answers on a cooling system upgrade for towing. I'm going to be towing a 3 horse trailer, mainly over curvy roads with steep hills at low elevation, so it will be at slower speeds up to 50mph, the curves and hills are such that I will be going from speed all the way down to a...- 94ram1500
- Thread
- Replies: 9
- Forum: Towing & Hauling
-
cam or gears?
Hello everyone, question... I have a 94 1500 5.9, bone stock pu, I'm going to be buying and towing a two horse trailer, I haven't bought the trailer yet but I'm guessing between my horses, which average about 1200 a piece, and the trailer itself, the whole tow load will be 5,500-6,000 lbs, What...- 94ram1500
- Thread
- Replies: 2
- Forum: Towing & Hauling
-
cam or gears?
Hello everyone, question... I have a 94 1500 5.9, bone stock pu, I'm going to be buying and towing a two horse trailer, I haven't bought the trailer yet but I'm guessing between my horses, which average about 1200 a piece, and the trailer itself, the whole tow load will be 5,500-6,000 lbs, What...
