Was driving at 40 mph and engine stalled. Check engine light and etc flash light came on. Battery’s are 2 years old with 12.68 volts. Scan tool says the pcm is seeing 12.3 volts. Crankshaft position sensor was damaged by something scraping on sensor face. Couldn’t see what caused the damage to...
I agree with RC Turner. All those circuits may terminate at a common ground that is loose or broken. When there are multiple circuit problems the grounds should be checked, tightened and replaced if needed. The complexity of current automotive electrical components is mind boggling and loose...
Ok, tried to spin the engine and battery was at 11.78 volts after 2 days on the trickle charger. Just got a click at the solenoid. Got the last new H-7 AGM battery on the shelf at Walmart. Walmart didn’t have regular H-7. Guess I should feel lucky even if it cost $180 with a 4 year warranty...
The engine is rebuilt and hasn’t been started yet. I want to spin the engine without starting until I see oil pressure on the oil pressure gauge to make sure there is oil circulated throughout the engine before initial startup. The fuel line is disconnected at the intake manifold. I removed the...
Hi, Just finished installing rebuilt 5.7 in 2012 1500. I want to spin engine with starter to see oil pressure before running engine. Removed fuel pump fuse and engine won’t spin. What’s the best way to spin engine without starting? Thanks.
Hi, I’m installing the non mds rebuilt 5.7 in a 2012 Ram 1500. What is the process for deleting the mds in the engine controller? The engine was rebuilt with the non mds cam and plugs in place of the solenoids. Thank you.
Cost so far is about $4400. Reman engine was about $3600. I bought new water pump, hoses, radiator, thermostat, belt, pulleys and exhaust manifold studs. Add oil pressure sensor and fluids it all adds up quick. I got a bid of $8200 for a reputable mechanic using a Jasper reman. I'm retired and I...
I installed the pickup with a new o-ring and torqued the 1 bolt and 1 nut to spec. The oil pump is new. I think I need to install a oil pressure gauge. Thank you for your advice.
Hi all, brand new to this forum. Wife's 2012 1500 developed misfire on #1 cylinder. Exhaust valve lifter failed and took out cam lobe. After looking at all options decided the best was to replace engine with reman from Accurate Engines. After installation took truck out and after 50 miles code...
Hi all, I have a 2012 1500 Laramie that wiped the #1 exhaust cam lobe because of a bad lifter. After much research I decided to replace the engine with a rebuilt engine from Accurate engines. The process was tedious and on Thursday February 15th I started the new engine. The following day I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.