timing

  1. C

    06 Ram 1500 4.7 please help

    Ok here it is, I have an 06 Ram 1500 and the oil pump went out, causing it to overheat and blow a head gasket. As the truck has over 300k miles on it we opted to go for a rebuild versus a repair. Since then the mad scientist and I tore it apart and we have replaced the pistons, rings, entire...
  2. Manual Gen 4 Ram

    Accidentally misaligned cam and crank... Please help

    2014 Ram 1500 Sport 5.7L After replacing the camshaft and lifters my truck a few months ago I was going into limp mode, but only when the engine was cold. I checked the computer and it showed codes P0016, P000B and the timing changing between -13 and -16° off. The engine ran fine other than the...
  3. Handy Smurf

    2020 ram 1500 15.5 MPG with 87 14.1 mpg with 89 octane

    2020 rm 1500 v8 Ran 89 octane in her and it dropped the MPG down to 14.1-14.5 AVG THis is about a 1 MPG difference since running the 87 I am unsure if there is any performance difference. At first the 89 seemed to improve performance but towards the bottom of the tank i feel like it...
  4. J

    Timing

    Hey guys so I put a new motor in my 99 ram 1500 its a 5.2 magnum. I set my timing and it starts off perfect but steadily climbs as it runs. Any idea what would cause that?
  5. M

    2010 5.7 Dodge Ram

    P0016. 180 k Runs very good but CEL came on with P0016 - P0340. Changed spark plugs, Cam Sensor, Crank Sensor, and VCT solenoid. Went through 5 drive cycles and CEL came on again, this time only P0016. It seems to be thrown at deceleration and advance timing is around 4 degrees. It runs very...
  6. SuperUnknownSG

    Headlight Issues

    So I installed so very beautiful Taillights on my 2018 ram 1500. I had to use a harness that stole some signals off of the 7 pin trailer connector. I notice now that my timing from the front signals to the rear signals are slightly off. Is there anyway to fix this? Can I change the timing somehow?
  7. R

    Does this look correct?

    5.9 360 at TDC, is this the correct rotor position?
  8. M

    Resetting fuel sync

    Does anybody know of any way to reset the fuel sync with anything other than an actual drb3 or snap on mt2500 or newer. Something like the launch creader123 or even a programmer
Top