Jukebox64
Junior Member
Hey Group,I am new to the forum so this it my first post. I am thinking of adding some blue LED accent lights in the grill. My question is,has anyone else done this and if so,where did you wire them in?
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
That plastic plate just to the right of the boot mentioned above is where I ran the long body harness for the OEM backup camera. I just drilled a hole it it while leaving it in place , installed a rubber grommet and ran the harness through it . This worked out great and I now have room to run additional wires for future mods similar to the OP.Ya there is a 3-4 inch long black piece on the firewall opposite the steering wheel. It's held on by two 13 mm nuts from the inside of the cab. It's a pain with a ratchet. If you got an air ratchet it's a breeze. Pop out out and drill it. Or just leave the thing there and drill it. You should be safe if you use a short bit.
Ya there is a 3-4 inch long black piece on the firewall opposite the steering wheel. It's held on by two 13 mm nuts from the inside of the cab. It's a pain with a ratchet. If you got an air ratchet it's a breeze. Pop out out and drill it. Or just leave the thing there and drill it. You should be safe if you use a short bit.