- Joined
- Dec 1, 2013
- Posts
- 12,803
- Reaction score
- 12,501
- Location
- Bristol , Tn.
- Ram Year
- 2014 4X4 QC Express 6 speed auto 355 differentials
- Engine
- 5.7 Hemi
Fitment , should work.I have been doing a lot of research and I believe that the setup I want will work but I'm looking for some reassurance. I have a 2015 Express 1500 4x4, was going to use a moto fab leveling spacer kit 3" front 2" rear. 17x9 -12mm 4.5bs wheels with 35x12.50 grabber at2 tires. Will I have any rubbing or fitment issues? Also are there any long term side effects with this setup? I rarely go off pavement. Thanks in advance for any impute and advice!
Rubbing , should not .
Long term issues , likely ...ie UCA Ball joints & with high angle stub Shaft spline wear & vibes .
Issues may take longer with zero offroad use ; however, the high angle on the splines that will be created by a 3" spacer sometimes causes vibrations right away.
The above is just my opinion, and you know what they say about opinions
I suggest reading here ...a lot of fantastic info . If you've read this already , I suggest reading it again .
Start at post #1 and follow any suggestions mentioned by the OP (Brandonjanson) , again this is my opinion...
http://www.ramforum.com/showthread.php?p=1087055
Last edited: