TX_SHOCKER
Junior Member
- Joined
- Sep 22, 2014
- Posts
- 23
- Reaction score
- 4
- Location
- Beaumont, TX
- Ram Year
- 2010 2500
- Engine
- Cummins 6.7
truck is a 2010 2500 cummins with the 6.7
Ok so yesterday I got some fuel ( yes Diesel lol ) and got about $20 worth. Tank was at 1/8 before I got fuel. After I put the little bit in I drove a few errands without an issue. Came home and it sat for about 1 1/2 hours and then I went out to eat and it started just fine. Well at one red light the truck idled rough ( kinda like an engine with a big loping cam) but as soon as I started driving it was fine. I pulled into the parking lot of the restaurant and it was really running rough but still drivable. I gave it a little rev and it sounded like it wasnt running on all 6 cyclenders. I shut it off and went inside and ate. Came back out and no start it would crank over just fine and it acted like it wanted to start but no go. I drained the diesel from the filter thinking maybe there is some water in it. i did that 2 or three times but still no start.
Any suggestions?
I have very limited hand tools and only scanner i have is my H&S tuner which is not picking up any codes.
Ok so yesterday I got some fuel ( yes Diesel lol ) and got about $20 worth. Tank was at 1/8 before I got fuel. After I put the little bit in I drove a few errands without an issue. Came home and it sat for about 1 1/2 hours and then I went out to eat and it started just fine. Well at one red light the truck idled rough ( kinda like an engine with a big loping cam) but as soon as I started driving it was fine. I pulled into the parking lot of the restaurant and it was really running rough but still drivable. I gave it a little rev and it sounded like it wasnt running on all 6 cyclenders. I shut it off and went inside and ate. Came back out and no start it would crank over just fine and it acted like it wanted to start but no go. I drained the diesel from the filter thinking maybe there is some water in it. i did that 2 or three times but still no start.
Any suggestions?
I have very limited hand tools and only scanner i have is my H&S tuner which is not picking up any codes.