Just finished test drive after installing my carven direct replacement muffler. Cold start inside the shop sounded awesome. Drove it a couple miles and it calmed down after warming up. Sounds great while on the gas. Not as loud idling or at cruise as I thought it would be. May remove the...
Received my vararam yesterday, but my left front hub bearing decided to delay installation. Replaced hub after work yesterday evening and just finished up the vararam. Love the old school Mopar look. Will see how i like it on the 45 minute commute tomorrow morning. Then installation of my carven.
I purchased 70% rate increase for my 16 crew cab 4x4 1500 from Michigan truck springs. I also use a wdh with my travel trailer. They raised the back of my truck so that I replaced my 2inch coil spring spacers with 1 inch and still sit a little high in the rear unloaded. And yes it is a little...
2016 ram 1500 4x4 crew cab 5'7"bed 5.7 hemi. Towed my 33ft travel trailer 10600 dry weight. Longest pull was from northwest Florida to gaitlinburg. Pulled it just fine in left lane a lot, cruise 7
set 78-80mph. 7.4mpg lol
Just ordered my vararam cai and carven progressive for my 2016 1500 4x4 crew cab Laramie 3500 miles on my new jasper engine following cam failure, should be here next week and hope to install next weekend. Plan on following up replacement of stock manifolds and a tuner.
Can anyone tell me where the fuel temp sensor is located on a 2016 ram 1500 hemi? Already replaced the fuel pump assembly due to guage failing and still getting a code for the fuel temperature sender
Got my truck back yesterday from the shop. Decided to go with a Jasper replacement engine. After putting roughly 100 miles on it, I am thinking it had lost some power a little while before the indications of the cam/lifter issue. Or maybe could have getting back in it from tge borrowed 2.2l s10...
Thanks for the replies. My local dealer has the cam and liftersin stock. A bit of sticker shock on oem lifters, $457 for the cam seems fair. $1034 for complete set of lifters. That was a little shocking. Truck been paid off about 8 months, go figure. Still a lot cheaper than another truck. Just...
New to the forum. Have read a lot of threads in the last couple days on the #3 misfire.
i have a 2016 1500 laramie 4x4 crew cab with 208k miles (all stock other than small lift and bigger Toyo M/Ts) and got the #3 cylinder misfire. Of course suspected coil/plugs. Changed them, still misfiring...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.