-
-
6speed4.7 reacted to Geawiel's post in the thread Beltech 2/4 kit popping after (I've already replaced control arms, track bar and reseated torque after 4 months use) with
Like.
Everything got white lightning as I put it back together. Not dealing with seized **** like I had to when I took it all apart. Also... -
6speed4.7 reacted to Wild one's post in the thread Beltech 2/4 kit popping after (I've already replaced control arms, track bar and reseated torque after 4 months use) with Like.
If you're using a 2 post lift,you're better off torquing the arms with the springs removed,as you can use stands under the axle to...
-
6speed4.7 replied to the thread Beltech 2/4 kit popping after (I've already replaced control arms, track bar and reseated torque after 4 months use).I think as long as you torqued everything (control arm front/back bolts, shocks, panhard bolts, sway bar end links) to ride height...
-
6speed4.7 reacted to Rock Crawler's post in the thread Beltech 2/4 kit popping after (I've already replaced control arms, track bar and reseated torque after 4 months use) with Like.
When installing the rear control arms, did you tighten the bolts after the weight of the truck was on the suspension, or while the rear...
-
Did you ever remove the springs and jack it up till things hit or go into a "bind". The front of the locating arms are also a known...
-
I would give IHC a call. I'm not certain who installed your kit but, installing the upper control arms on the incorrect side, putting...
-
Dig out your tape measure and start shortening up your adjustable arms,take your time,and triple check everything so you don't shift/c o...
-
6speed4.7 reacted to Daw14's post in the thread Another PCV adapter to put a catch can on a 6.4 with Like.
Maybe if that feller searched our forum for the contents of some of these cans that members have posted , it may change his opinion...
-
6speed4.7 reacted to Bigskyroadglide's post in the thread 2016 ram 1500 rcsb build thread with Like.
Information from Core 4x4 is 140 ft lbs. See attached. This is for a 2012
-
It doesn't hurt to go over all the bolts every couple months and make sure they're still staying torqued.I don't think a 100 lb-ft is...
-
6speed4.7 reacted to Bigskyroadglide's post in the thread 2016 ram 1500 rcsb build thread with Like.
Great minds. Harbor freight $4.99
-
it slammed really bad with just the beltec drop springs and stock shocks was better with relocation brackets and qa1s seems good now...
-
Everything is tight as far as I know i used some loctite and a impact with 100ft-lbs i'll check them here and there
-
6speed4.7 replied to the thread 2016 ram 1500 rcsb build thread.Sorry, re-read Bigsky’s last post, and I went off on the wrong tangent Question to the OP what torque numbers did you land on for the...
-
6speed4.7 replied to the thread 2016 ram 1500 rcsb build thread.Good catch on the relocation bracket bolts Doesn’t look like a lot of thread showing past the nut The Trekline instructions provided...
-
-
Loading…
-
Loading…
