If you buy Moog, make sure you get the "problem solver" line. Those are usually still made in USA and are a lot better quality than their cheaper stuff.
I changed lower and upper ball joints and tie rods with moog problem solver. Its been 7 years. Still no problems.
The sway bar links were...
handycruiser, its great to see you keeping up your truck! I have an 03 exactly like yours. Mines also been in the family since new.
This week I installed a dash cover since my dash unfortunately started cracking a few years ago. if I ever have to replace the heater core Id like to put in a...
I use a fan clutch holding tool and a 1/2" breaker bar with a 36mm crow foot wrench
You can make your own fan clutch holding tool or buy one
Theres videos on youtube
Where is the needle on the coolant temp gauge?
Does the temp warning light turn on?
EDIT: After re-reading your post it sounds like the gauge is getting to 3/4 of the way; In between middle and the red?
Check for engine codes if you have the equipment.
I have an 03 with the 4.7L.
Only major issue I've had is a misfire caused by a bad head gasket. Expensive fix at a mechanic.
The check engine light would turn on when the engine was cold or had been sitting for a while. Then it'd go away.
A...
I have a few thoughts:
1. Did you buy an OEM fan clutch? The only aftermarket clutches available are heavy duty and severe duty clutches which engage more often (at lower temperatures) and spin faster (more noise) than OEM. Nothing will be quieter than the OEM fan clutch
2. You were driving up...
Are you referring to the pages from the manual I attached? I'm not sure if the auto shutdown relay even applies to your 07 or any tipm vehicle. Procedure is just a standard resistance and continuity checks across terminals with a meter like any other relay.
The 2006 manual states the ASD relay...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.