Recent content by HarrisFD

  1. HarrisFD

    SOLD - Console Safe for 2012 - 2018 RAM 1500, 2500, 3500

    Pm sent
  2. HarrisFD

    Wanted Gen 4 OEM Led Tail-light Harness

    Anyone know where to get these pigtails for a 13 and later factory LED Tail light?
  3. HarrisFD

    LED taillight pigtails/harness

    I’m in same boat, are you selling the adapter harness? If not do you have a parts list so we can make our own? I too want to convert from halogens to oem led’s and change settings in Alfa obd. The resistor thing seems like a fire looking for a place to happen.
  4. HarrisFD

    Hi Beam Circuit tie-in

    Good info, so a buck fifty diode and a couple solder joints would be cheap insurance. Any thoughts on diode values and placement in circuit? Thanks for info.
  5. HarrisFD

    Hi Beam Circuit tie-in

    Thanks for the insight, while I could eliminate the switch I’d like to have the option of disabling the 520’s when there’s other traffic around. Normally the dot 520’s are 55w, these are nearly double. They are not street legal and I’d have to switch to low beams pretty early if I have oncoming...
  6. HarrisFD

    Hi Beam Circuit tie-in

    2015, Why Under hood and not under dash? Will computer wig out? Relay Trigger is a pretty small draw.
  7. HarrisFD

    Hi Beam Circuit tie-in

    So I’m in the process of making my 2015 2500 more deer proof. I just installed a Trailready pre-runner bumper and PIAA Fogs and 100w driving lights. The fogs I wired to plug into stock harness, but the drivers are wired into a relay. I want to trigger the driving light relay off the hi beams and...
  8. HarrisFD

    Intercooler duct retainers

    Not worth searching for hours on end. The Napa retainers work fine, new Intercooler is back on truck.
  9. HarrisFD

    Intercooler duct retainers

    Checked local dealer, they have no clue what part# is, and it does not appear that they come with the flat shroud piece (aka "seal"). Napa doesn't have an exact replacement but Balkamp 665-1000 will work.
  10. HarrisFD

    Intercooler duct retainers

    Hi I’m in the process of fixing my 2015 6.7 4x4 from the last deer strike and I have run into small roadblock. I’m trying to find the plastic retainers that hold the flat plastic duct to the top of the Intercooler ( aka “seal”). Apparently they come with the new duct but are not listed...
  11. HarrisFD

    Help! Lost WIF sensor connector seal.

    Awesome thanks.
  12. HarrisFD

    Help! Lost WIF sensor connector seal.

    I recently changed out the Fuel filters on my 2500 6.7 Cummins and later I found a little oval yellow wire connector seal on the driveway. I saved it, figured I’d put it back in later. Well time went by and I now I can’t find the stupid little seal. It goes in the female connector that clips to...
  13. HarrisFD

    Totaled??

    You’d be amazed at what they will total a vehicle for these days. I bought my 2015 Cummins 4x4 off of auction. It was “totaled” after rear-ending a Jag. Cost a grand total of $1400 to fix: bumper, intercooler , grille. Frame was untouched, minor 2” dent in front of hood. I’d say they’re going to...
  14. HarrisFD

    Yukon Limited Slip or AAM Helical or Eaton Helical?

    K thanks, one of the potential issues I see is that if you have a 4th gen ram with AAM 11.5, Eaton website says you have to swap to earlier ring and pinion to run the Truetrac. Guess I’ll call their tech line to confirm or see if there is a newer part number.
  15. HarrisFD

    Yukon Limited Slip or AAM Helical or Eaton Helical?

    Did you put it in a 4th gen? Did u have to change to earlier ring & pinion?
See more

Latest posts

Members online

... and 7 more.
Total: 1,288 (members: 57, guests: 1,231)
Robots: 1,875

Forum statistics

Threads
195,645
Posts
2,872,867
Members
156,481
Latest member
Williammoody150

Share this page

Top