-
-
HDoes the 2013 have the front driveshaft hidden grease fitting? I have looked but can’t find it anywhere Highway
-
HI've used it as an engine oil flush. Did this just before I put in the Liquimoly Molygen. Seemed to work. Nothing bad happened. Some...
-
HSea foam as a flush? Maybe we should consider it? I hate the guy used Lucas, lol.. 2nd vid results 3k miles. TBH I didn't think...
-
HHighway replied to the thread What did you do with your 4th Gen this week?.I tackled the front end, new cv axles , intermediate shafts on both sides , upper control arms and pressed in new ball joints. Just...
-
HHighway reacted to Bandit517's post in the thread What did you do with your 4th Gen this week? with
Like.
I went from a Carven Progressive to a Flowmaster FlowFX for the same "Getting old" reason. After long tubes and offroad Y pipe the... -
HHighway replied to the thread What did you do with your 4th Gen this week?.How loud is the “18 ?
-
HHighway reacted to Warlock2024's post in the thread What did you do with your 4th Gen this week? with Like.
So far this week, all I have done is drive to work. Plan on driving back home this afternoon! :) However, over this past weekend, I...
-
HHighway reacted to RebelDad's post in the thread What did you do with your 4th Gen this week? with Like.
Ordered a 18" magnaflow. Was gonna go with black widow but really just want to quiten it down a good bit. Currently have the bolt in...
-
HHighway replied to the thread AlfaOBD programmed a replacement Key fob ok but it stopped working.I order my keyfobs from this place and have good luck
-
HHighway reacted to Jeepwalker's post in the thread Passenger side Intermediate axle shaft with Like.
I think I've seen them at Amazon as well ...but i know you already ordered one.
-
HHighway reacted to Dodge 1500 4X4's post in the thread Passenger side Intermediate axle shaft with Like.
These guys have the whole kit including seals and bearings. https://rickroodstransmission.com/
-
HHighway replied to the thread Passenger side Intermediate axle shaft.Not for sure on that, the one i got from rockauto had the needle bearing installed already
-
HHighway replied to the thread Hard detail paid off.Looks great
-
HI did a complete paint correction then ceramic coating. I upgraded the taillights, headlights, had the front & back bumpers repainted...
-
HHighway replied to the thread Ordering a No Splice Kill Switch Harness.do these not work on a 2013 ?
-
-
Loading…
-
Loading…
