-
-
Some of you guys need to spend 15 minutes and read this article.There seems to be alot of mis-information on here regarding Shorty and... -
EdGs replied to the thread 8hp70 fluid.There have been several threads on here with members using Valvoline MaxLife in their ZF 8 speeds, and IIRC, all had great results. You...
-
Once you get it back together, you'll still need to bleed the remaining air. Just to the right of the thermostat housing is a recessed...
-
Jiggle pin is up above the coolant level or at 12:00, also leave radiator cap off a bit after filling it up to bleed the air out.
-
EdGs replied to the thread 2004 5.7 thermostat pin up or down?.Yea, did leave the cap off, also blocked the rad with some cardboard to help it warm up faster. It took almost another quart ish after...
-
EdGs replied to the thread 2004 5.7 thermostat pin up or down?.Not on this hemi, no bleeder I can see. thermostat faces driver side. Other 5.7's I have seen have the bleeder that you mention. My '15...
-
Move out of California...
-
EdGs replied to the thread 2004 5.7 thermostat pin up or down?.I really appreciate all the good info from all. His heater core definately has an issue as there is no heat in the cab at all. To be...
-
EdGs replied to the thread ZF 8 speed transmission fluid change.Seems like all I see are good reviews for that stuff.
-
EdGs replied to the thread 2004 5.7 thermostat pin up or down?.thermostat on his faces driver side, no bleeder screw. Sorry, am out in the sun. Your pic it looks like down. I was under the...
-
EdGs replied to the thread 2004 5.7 thermostat pin up or down?.Thanks. Does the pin on the thermostat go on top or bottom. As you can see. the original was down, which I believe is wrong.
-
-
Hello all, Helping my nephew install a new water pump on his 2004 1500 with the Magnum Hemi 5.7. We noticed that the pin on the...
-
-
EdGs reacted to crash68's post in the thread Accidentally put Transfer Case oil in Rear Diff with
Like.
I doubt you would have done any damage to the differential even if you ran the transfer case lube for several hundred/thousand miles... -
It honestly wasn’t all that tight, it just broke free so sharply and I was using just an allen wrench. The wet rags Wild one recommended...
-
EdGs replied to the thread ZF 8 speed transmission fluid change.Nope, sure didn't. I was so careful, too. And then, ssss! @&%$*@×&%[email protected]#!!!!
-
-
Loading…
-
Loading…
Staff online
-
rule18Admin
Members online
- John Mancino
- Jwithing
- Graykirk
- Daniel Anderson
- GRKN
- Westwind1124a
- Mercruth
- GTyankee
- bigdodge
- ntc0167
- mountainlion
- Ramrt345
- Dinky
- Jjssnow
- VanillaGorilla2015
- CaptainMax
- ViperRich
- Kenobi
- Jardad5
- 2016outdoorsman
- ThunderMug95
- Mcginnis
- Chris Dennis
- mdc1990zr1
- Ram1683
- Sdpadrez
- Rodp84
- Abrams117
- Megabyte1982
- KevinInVT
- Sweetee
- Lubeman
- bulldog1891
- Wild one
- oe542bob
- goggles
- Dean2
- 18CrewDually
- DILLIGAF
- JoeCool
- 06ram
- PeeDub2022
- rule18
- Marshalljud
- Curt Gobbell
- BULLDOGG353
- SixAddict
- BWL
- RodeoRam
- the1adman