Recent content by Jteck627

  1. Jteck627

    Lifted 4th Gen Pics - Show Em Off!

    bilstein 5100's set higher, aftermarket UCA's, fuel rims, nitto MT's. bought her like this and need to fix a couple small little things to get her more level
  2. Jteck627

    Engine code confusion

    a few weeks ago my trucks check engine light came on randomly, U0140 ($07E9) - i believe for the Body Control Module i was trying to pass smog, so i used an odb2 scanner and cleared the code. after driving around a bit, the code never came back and the truck passed smog. then this past...
  3. Jteck627

    Paint code confusion?

    Hey all, a bit confused here - or maybe in not looking in the right direction i have a '13 outdoorsman that has a rust hole on the drivers side rocker panel. i'm going to try and cut/weld on a new piece myself, but cant find the correct paint code my door jamb says paint code PS2 and trim code...
  4. Jteck627

    Alright guys.. BILSTEINS post your pics!!!

    will do!
  5. Jteck627

    Alright guys.. BILSTEINS post your pics!!!

    and done. Bilstein 5100's all around, front at 2.8, Mevotech UCA's, MaxLinks 3" end links Mickey Thompson 35x12.5x20 on stock 20" wheels no rear spacers and no wheel spacers. dont see a need as there's no rubbing at all and rake is fine now i just have to figure out how to get a 35" mounted...
  6. Jteck627

    Alright guys.. BILSTEINS post your pics!!!

    picked up the tires today should be done by tomorrow going to wait til everything's on to see if i need spacers or not
  7. Jteck627

    Alright guys.. BILSTEINS post your pics!!!

    after reading this thread for about a month, i finally pulled the trigger on all the stuff for a level and tires now just have to wait for it all to show up to install : Mickey Thompson Deegan M/T - 35x12.50x20 (there was a sale at 4wp) Bilstein 5100 on all 4 corners (planning on the 2.8...
Top