Recent content by Ken Dillinger
-
K
Rotary Shifter
After a week, you won't even think about it. You'll reach over and flick it into drive without hesitation. It will literally be 1 second out of your drive time regardless of shifter type. There are much bigger things to obsess about, like how not to spend a fortune in mods and upgrades.- Ken Dillinger
- Post #30
- Forum: Interior
-
K
Mopar Backup Camera Troubleshooting
I finally got it. All of the harnesses and connection points tested good. However, I was not getting 12vdc back to the camera on pin 1 of the camera connector. I ran a wire from the battery and tucked it into the connector at the bottom of the tailgate, on the camera power wire. Camera came...- Ken Dillinger
- Post #4
- Forum: Audio & Electronics
-
K
Install
A recommendation I have is to get a roll of fabric wiring harness tape, such as found here https://www.amazon.com/dp/B01LYZDN2X/. Use it to tape any harnesses or bundle of wires to give a "factory" look, very clean (this tape is not electrical tape). It also helps to keep any wires from...- Ken Dillinger
- Post #15
- Forum: Audio & Electronics
-
K
Mopar Backup Camera Troubleshooting
Thank you kindly for the advise. I did the following: 1) Verified, have .3 ohm from fender to fender, cleaned up connection anyway 2) Revisited PDC, pin still inserted completely in connector, fuse still good, everything looks good here 3) Solder joint on PDC wire splice is good, solder joint...- Ken Dillinger
- Post #3
- Forum: Audio & Electronics
-
K
Mopar Backup Camera Troubleshooting
I installed the Mopar OEM backup camera kit last week. First of all, let me say that the post in this group was a major help, reading it before hand made the install a breeze. I knew before hand that the connector drawings were from the wire side of the connector, not the interface side. But...- Ken Dillinger
- Thread
- oem backup camera
- Replies: 6
- Forum: Audio & Electronics
