Recent content by Macko88

  1. M

    master power power switch

    New module and new master switch still the same problem. Checked wires in between the door and body every wire looks good.
  2. M

    master power power switch

    Its a 2012. i have attempted to clean it with no luck. probably will try again today and see how that goes. while pressing one of the buttons that uses the line bus should there be a change in voltage? with a voltmeter on the line bus it read 2.3V while pressing one of the buttons and when the...
  3. M

    master power power switch

    master switch will control the 2 back windows. None of the other controls work. windows work from the local door switch. Locks work on the passenger door. it does have 12 volts at the switch. Unsure of what should be done next to diagnose the issue. any suggestions would be appreciated
  4. M

    Window trouble

    both front windows, mirrors, door locks all have stopped working on my pick up. I can control the two rear windows. It does have 12 volt power to the switch. Took the main switch from a buddies truck installed in mine with no change. Window motor works. No change in voltage in the line bus when...
  5. M

    Engine codes.

    I used the internal diagnostics. I let it sit for awhile attempted the codes again. This time i pulled P-0562 low battery. a friend of mine has diagnostic tools. We are going to try to use later. thank you for the advice!
  6. M

    Engine codes.

    My Ram threw some codes the other day. I pulled the codes also looked up a diagnostic chart. The codes i pulled are P-0606 Internal Control Processor P-061A ETC Level 2 Torque Performance P-014C O2 Sensor Slow Response Rich to lean P-02E8 Diesel Intake Airflow Position Sensor Circuit Low Any...
See more

Latest posts

Staff online

Members online

Total: 386 (members: 14, guests: 372)
Robots: 866

Forum statistics

Threads
195,780
Posts
2,874,376
Members
156,698
Latest member
brendo99

Share this page

Top