X2 on checking that tail to muffler connection for proper alignment. Also, the factory tips do have some adjustment fwd and backwards but I’m not sure about the ones you’ve installed.
I took my door panels off and tapped them with the end of a screw driver and listened for any rattles, most of mine came from the places that had plastic welds. I cut strips of sound deadening and worked them in and around all those seems. That took most of them away but the window switches are...
Let that blaster sit for a night or two and then maybe add some heat to that area and try again. Also use a file to add some square corners to what’s left hanging out and try grabbing and turning.
You could also take it to the dealer and see if the guy who does the exhaust manifold bolts can...
My experience on a work Ram was that the connector looked fine when disassembled but when assembled one of the pins pushed back and eventually backed out enough to ask the headlight go out. Apples to oranges I know but similar in concept. You might try pulling on the wires while connected to see...
I just took the Mufflex 24 off of my truck. It’s quiet at idle and has bit of trowel at WOT and some drone at low speeds with the 8 speed in my truck. There was an airy burble that I just couldn’t get used to and that’s why I took it off.
Hope this helps.
This has been an issue since I was a teenager, headers always leaked in more than one place most of the time. Times have changed and so has technology but one thing is constant when it come to this issue, aluminum and cast iron heat up and cool down at different rates which has the most to do...
You will get a ton of different options here with those questions. I kept the factory HU so the steering wheel controls would stay functional. I added speakers all around an amp and a DSP plus all new speaker wiring. This and tuning your amp will give you good results for the dollar amount your...
I installed the homelink transmitter and wired it according to the schematic for my truck and then had the sales code added. My new in the box transmitter operated my garage door about 3 times and then just stopped? I replaced the transmitter since the buttons no longer lit up. The new...
Follow up,
I contacted RAM Cares and talked over my issue and was told all work for swapping cylinder head including labor is covered under my warranty and if the dealership tried to charge me I should tell them to call which I did. After talking to RAM Cares my out the door cost was my...
I’m guessing it’s simply an extension of the factory warranty by the dealership? The truck isn’t at the dealer I purchased it from which is why I think that way.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.