I have an 03 ram 4.7 truck with a rough idle and it seems to be only when the truck gets warm. I have had a po440 and a po441 code. I've recently changed the fuel cap and canister purge solenoid and it fixed my problem for a couple weeks. I've replaced a couple old hoses and I'm just running out...
Has anyone had to buy this connector?
Everyone including the dealer is trying to sell me the 4 prong one that plugs into the blower resistor.
Attached pictures show this one plugs into the blower motor and is a 2 prong 2 wire.
I purchased some NAPA Reflex shocks about 6 months ago (supposed to be monroe or compare to them) at $58 a shock I hoped they wouldn't suck so bad. Super bouncy and already feel like my stock shocks when they had 120k miles on them..
What are you guys running?
The truck i'm running them on...
Post up pictures of your aftermarket headlamps!
Purchased some tinted ones off ebay.. love the look, hate the visibility at night.
I'd like to get some ideas for some others.
This happened to me and nearly drove me insane..
Mine ended up being the tail light circuit board. Took both taillight assemblies out and checked the 3 bulbs on each one. Where one of the bulbs clicked into the circuit board was loose and wasn't allowing full contact for the bulb.
Check...
I have an 03 4.7 with 120k miles
19-20 highway mpg and 14-15 in town
Had issues with gas mileage right after I hit 100k
changed plugs and O2 sensors and it went back up after that
I've been looking at several loaded sub enclosures with an amp.
I'm not into the shaking every car and house around me within 2 miles sound..
Just some bass to shake my side mirrors.
I've looked into bazooka tubes.. seem big to be going in a single cab and the Kenwoods don't seem to...
I have an 03 4.7 ram. I have bought THREE belt tensioners from napa and they keep going bad.
All 3 times they were put on by different shops. This last time has lasted longer than most.. now i'm back to the squealing and shaky tensioner..
has anyone else had this issue? should I spend the...
Finally gave in and took it to a shop.
Come to find out my trusty new thermostat was defective..
Guy at shop said there is a way to run a vacuum when filling the cooling system on these trucks. No issues since it was fixed on Monday
Flushed system and changed hoses and thermostat on 03 ram 4.7
Followed instructions on how to use bleeder valve to properly bleed the system
Now the gauge wont go up to the half way mark of normal operating temperature.. When I floor it it shows to actually get cooler?
What is going on?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.