Search results

  1. D

    HPTuner Ease of Use

    Hello, I’m thinking about getting HPT for my 2017 Ram. Already bought a donor PCM a while back and it’s just sitting in my garage because I’ve been hesitant to pull the trigger on getting the HPT setup. I was wondering how easy their software is to use with our trucks. As of right now, all I...
  2. D

    Antifreeze Testing

    Hello, I recently did a coolant flush on my truck and refilled with Mopar OAT 10 year coolant as suggested in the forum. I've been having a hard time trying to find out if my mixture is correct. At first I was using a bulb tester to check my mixture. After trying to correct it several times...
  3. D

    BW44-44 Transfer Case Fluid

    Hey guys, Looking to do a fluid swap in my t-case this week. I’ve read that guys are running Amsoil MVATF without issue. That fluid seems a bit tough to find where I am so I’m wondering if anyone has tried Valvoline MaxLife ATF in their 44-44. Got a few bottles of it on the shelf in my garage...
  4. D

    PCM Swap

    I'm thinking about buying a used UNLOCKED PCM. The PCM was unlocked by HPT and the guy is no longer using it. What information do I need to make sure that this PCM will work in my truck? I know that I'll have to program my VIN to the unlocked PCM but other than that, what is involved? Does...
  5. D

    Factory Projector Retrofit

    Hello, I'm considering retrofitting my factory projectors with the Morimoto Mini D2S 5.0. I've never retrofitted a set of headlights before so I just want to make sure I have everything before I bake these. 1. I plan on ordering the projectors, the mounting brackets, and new rubber butyl for...
  6. D

    Factory Projector Spread

    Hey guys, I have a set of Morimoto HIDs installed in my factory projector low beams. I notice that the light pattern on the driver side does not match the passenger side. I have tried turning the bulb in the holder while the lights are on to try and get the light spread to change. It does...
  7. D

    Inverter Install Gone Wrong

    It’s just my luck that I managed to tear at least one wire in half while pulling cable for an inverter install. Don't ask why I didn't use the empty hole beside it :emotions122: The break is inside the firewall rubber boot where all the wires go through. Any idea what this wire might be for? I...
  8. D

    Heated Seat Questions

    Hello, I just added Dorman heated seat pads over my factory seat pads in my driver seat as my factory ones have a short in there somewhere. Dorman heaters were spliced into factory heated seat wiring. With AlfaOBD, I’m able to see that these new heaters are drawing 5.5 amps. What is the...
  9. D

    2017 Sport CC Rear End Wobble

    Hey guys, I’ve been trying to figure out a slight vibration/wobble in my truck. It feels like I’m driving over a very subtly bumpy road. I just replaced my brake pads and rotors. Issue was there previously but almost seems worse after the brake job. There is no vibration when braking and I...
  10. D

    Stock Air Suspension Issues

    Hey guys, After 5 years of Canadian winters, I have finally started to get the dreaded air suspension issues on my Ram 1500. A message appeared on my EVIC: “Immediate Air Suspension Service/Repair Required”. Fortunately, the truck threw this error while in normal ride height so I don’t have...

Latest posts

Staff online

Members online

... and 8 more.
Total: 1,396 (members: 58, guests: 1,338)
Robots: 1,937

Forum statistics

Threads
195,648
Posts
2,872,883
Members
156,483
Latest member
Jayhull82

Share this page

Top