Search results
-
D
Oxygen sensor wiring
Replacing my upstream o2 sensor. Right behind the plug on the harness side is one broken wire. There's no way I can get both hands up there to splice it. Does anyone know where the harness routes up in the engine bay.? The plug is on top of the transmission in the middle. I can't see where the... -
D
Fuel pressure issue
So, last weekend truck decided not to start. Went thru fuel system checks 1st. Fuel relay checks good, pcm good, power at relay pin 30, fuse good. Jumped pin 87 & 30........pump runs, but no fuel pressure at the fuel rail. Zero according to fuel pressure gauge. I see no leaks between tank &...- dragracer
- Thread
- Replies: 4
- Forum: General Discussion
-
D
Alternator options
My truck is 2001 Ram 1500 5.2 liter- dragracer
- Post #2
- Forum: Engine & Performance
-
D
Alternator options
Wondering if an alternator off a 2004 jeep 4.0 will work on my 5.2 Ram. Both densos. Same plugs/case. Reason I'm asking is I put a new one on my jeep. Returning jeep to dealer because they cannot get the title. Long story. Hate to leave a $180 alternator on it. Was going to swap it with my 01...- dragracer
- Thread
- Replies: 2
- Forum: Engine & Performance
-
D
OEM Running Board Help
Yep, what you have/had. Figured I would be drilling, just hoping not. Thanks -
D
OEM Running Board Help
Wondering if anyone has these on their truck. Would be nice if I could find original instruction sheet. I bought a set of oem molded running boards for my 2001 Sport. These are the ones offered in 2000-2001. They run the length of the cab. Needed advice on installing. Wasnt sure if... -
D
Electric fan controllers
Painless Performance: Fan Relay w/thermostatic switch 185 degrees On/175 degrees Off I assume you already have it wired up. So you could just get the switch to replace your controller. Or get one of the painless controllers. I like the thermo switch better. Turns fans on at a preset temp...- dragracer
- Post #4
- Forum: Audio & Electronics
-
D
Electric fan controllers
Look into Painless Wiring. I ran a kit that used a sensor mounted in coolant. If you have a place to mount it in the intake or other coolant passages. I liked this better than a controller. They have 180 or 195 temps. Switch opens at whichever one you get. Will see if i can find part # Rich- dragracer
- Post #2
- Forum: Audio & Electronics
Latest posts
-
INFO - 2013-2018 8.4A /AN FW Notes (RA3/VP3-NA & RA4/VP4-NA & UAx)
- Latest: OasisNinjaBat
-
-
-
-
Staff online
-
G-Ride990Administrator