I have a 99 V-10 2wd auto trans I plan to do a Cummins swap. I purchased a 98 24v complete and have located a 47rh transmission. the 24v has a lot of electronics and someone told me If I used a P7100 pump I could run it without any electronics. I need some expert advice on if that can be done...
I've run out of ideas. this truck starts and runs perfect for 3 to 8 minutes then shuts off and will not hit a lick until many hours later and then it will start right up and run. I can squirt starting fluid in the throttle body and it tries to run so I have spark. Fuel pressure gage shows 45...
no mass air flow sensor shown. I got desperate and unplugged the security relay and it runs fine most of the time. misses a little a few times briefly but very driveable now. does not totally make sense..
I have a 1999 2wd V-10 that often will start to miss and kinda flutter and when you slowly push the accelerator down and the RPM gets to 3500 it takes off and runs perfect. also when it is missing at low RPM you can stomp the accelerator and it runs fine even at low Rpm for a short while...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.